Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › MULTI-TERRAIN MONITOR SYSTEM
RM38G0E _56 Audio / Visual / Telematics _100728 PARK ASSIST / MONITORING _0469675 MULTI-TERRAIN MONITOR SYSTEM T

PARK ASSIST / MONITORING  MULTI-TERRAIN MONITOR SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

The following inspection procedure of the panoramic view monitor system is described on the assumption that the audio and visual system*1 or navigation system*2 is normal. If the audio and visual system*1 or navigation system*2 has any malfunction, first proceed with troubleshooting of the audio and visual system*1 or navigation system*2.

*1: w/ Audio and Visual System

*2: w/ Navigation System


·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>CALIBRATION



HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


General
Symptom Suspected Area Link
Screen does not switch when the multi-terrain monitor switch (trip switch) is pressed. Proceed to "ECU Power Source Circuit" Click here
Diagnostic mode - Signal connection check (CAMERA SW check) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Does not switch to the panoramic view and rear view screen when the shift lever is in R. Diagnostic mode - Signal connection check (CAN check) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Image not displayed on the panoramic view and rear view screen or rear view screen when the shift lever is in R. Proceed to "Image from Camera for Multi-terrain Monitor is Abnormal" Click here
Display does not switch to the see through view screen or moving view screen when the multi-terrain monitor switch (trip switch) is pressed. Diagnostic mode - Signal connection check (CAN check) Click here
Diagnostic mode - Signal connection check (CAMERA SW check) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Image not displayed on the see through view screen or moving view screen when the multi-terrain monitor switch (trip switch) is pressed. Proceed to "Image from Camera for Multi-terrain Monitor is Abnormal" Click here
Display does not switch to the panoramic view and wide front view screen or side clearance view screen when the multi-terrain monitor switch (trip switch) is pressed. Diagnostic mode - Signal connection check (CAN check) Click here
Diagnostic mode - Signal connection check (CAMERA SW check) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Image not displayed on the panoramic view and wide front view screen or side clearance view screen when the multi-terrain monitor switch (trip switch) is pressed. Proceed to "Image from Camera for Multi-terrain Monitor is Abnormal" Click here
Display does not switch to the retracted screen when the outer mirrors are retracted. Diagnostic mode - Signal connection check (CAN check) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Display does not switch from the retracted screen when the outer mirrors are not in the retracted position. Diagnostic mode - Signal connection check (CAN check) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here

Display Malfunction
Symptom Suspected Area Link
Objects not displayed correctly on the multi-terrain monitor screen (color, distorted image). Proceed to "Image from Camera for Multi-terrain Monitor is Abnormal" Click here
Distorted display on panoramic view screen. Camera view adjustment (calibration) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Parking lines do not match at front and rear on panoramic view screen. Camera view adjustment (calibration) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Partial black screen on panoramic view screen. Camera view adjustment (calibration) Click here
Proceed to "Image from Camera for Multi-terrain Monitor is Abnormal" Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Area displayed differs from the actual area. Ensure no door is opened -
Camera view adjustment (calibration) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here

Switch Function
Symptom Suspected Area Link
Combination switch assembly (multi-terrain monitor switch (trip switch)) night illumination does not illuminate. Inspect multi-terrain monitor switch (trip switch) Click here
Harness and connector -
Touch switch operation is not accepted. Audio and visual system - Touch switch self check*1 Click here
Navigation system - Touch switch self check*2 Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Radio receiver assembly Click here
The remote touch function of the screen does not operate for the multi-terrain monitor system. Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Radio receiver assembly Click here

Multi-terrain Monitor System Function
Symptom Suspected Area Link
When the vehicle speed increases in the automatic display mode, the panoramic view and wide front view screen or side clearance view screen remains displayed, without switching to the navigation screen. Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
The screen display timer function does not operate if the manual display mode is selected. Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
The estimated course lines do not match the vehicle width extension lines when the steering wheel points straight ahead. Check the steering wheel installation angle Click here
Adjust steering angle Click here
Camera view adjustment (calibration) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Estimated course lines stop moving before the steering wheel is turned fully left. Steering angle setting (calibrate stored maximum steering angle) Click here
"!" is displayed and estimated course lines are not displayed. Check if the back door is not open -
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Radio receiver assembly Click here
Estimated course lines are not displayed. Check the multi-terrain monitor screen display mode settings (Check if the estimated course lines display is set to off) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
"!" is displayed. Store the steering angle sensor steering neutral point Click here
Diagnostic mode - Signal connection check (CAN check) Click here
"!" remains displayed after the steering neutral point is stored. Adjust steering angle Click here
Steering sensor Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
"!" is displayed and all the buttons on the screen are grayed out. Camera view adjustment (calibration) Click here
Adjust steering angle Click here
Audio and visual system*1 Click here
Navigation system*2 Click here
"!" is displayed and all the buttons on the screen are grayed out even after television camera controller initialization has been completed. Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
Audio and visual system*1 Click here
Navigation system*2 Click here
Guide lines and buttons are not displayed on the panoramic view and rear view screen display screen. Check if the back door is not open -
Check if the luggage light turns on and off normally (If not, refer to Lighting System (INT) - Problem Symptoms Table) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here
"CHK" is displayed for an item on the Vehicle Signal Check screen. Diagnostic mode - Signal connection check Click here
Blind spots in image. Ensure no door is opened -
Camera view adjustment (calibration) Click here
Camera boundary lines are poorly connected. Camera view adjustment (calibration) Click here
Estimated course lines are displaced. Camera view adjustment (calibration) Click here
Adjust steering angle Click here
All buttons on the multi-terrain monitor are continuously grayed out. Audio and visual system*1 Click here
Navigation system*2 Click here
When adjusting the camera optical axis, "You can not calibrate the camera when the door is open. Please close the door." is displayed even after the back door has been closed. Check if the luggage light turns on and off normally (If not, refer to Lighting System (INT) - Problem Symptoms Table) Click here
Parking assist ECU (for LHD) Click here
Parking assist ECU (for RHD) Click here

*1: w/ Audio and Visual System

*2: w/ Navigation System