This DTC is stored when the rear television camera assembly receives an RCTA buzzer circuit malfunction signal from the blind spot monitor sensor RH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C2A5D | BSM Buzzer Malfunction | The RCTA buzzer circuit is abnormal | Blind spot monitor system | Rear Camera | A |
When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| RCTA Equipped Information | State of the RCTA equipped information | Without or With | Without: RCTA function not equipped With: RCTA function equipped |
- |
| RCTA Function | State of the RCTA function | Valid or Invalid | Valid: RCTA function is valid Invalid: RCTA function is invalid |
- |
| Tester Display |
|---|
| RCTA Equipped Information |
| RCTA Function |
| Result | Proceed to |
|---|---|
| "Valid" and "With" is displayed for all items. | A |
| "Invalid" or "Without" is displayed. | B |
A
B
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| C2A5D is output | A |
| C2A5D is not output | B |
A
B