| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | GENERATOR REGULATOR ASSEMBLY | 27700A | ( ) |
- | - |
| 2 | GENERATOR REAR END COVER | 27039 | - | - | - |
| *1 | GENERATOR ASSEMBLY | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
27700A 1.INSTALL GENERATOR REGULATOR ASSEMBLY
| *a | Pin (1.0 mm) | - | - |
|
Brush |
|
Generator Regulator Assembly Cover |
|
Push down |
|
Pull out |
While pushing the 2 brushes into the generator regulator assembly, insert a 1.0 mm (0.0394 in.) pin into the generator regulator assembly as shown in the illustration.
Push down the generator regulator assembly cover and secure the 2 brushes as shown in the illustration.
Pull out the pin from the generator regulator assembly.
| *a | Bolt | *b | Stud Bolt |
|
Push in | - | - |
Install the generator regulator assembly with the 2 bolts and stud bolt.
Push in the generator regulator assembly cover as shown in the illustration.
27039 2.INSTALL GENERATOR REAR END COVER