The radio receiver assembly and multi-display controller sub-assembly are connected by GVIF cable.
When a GVIF cable error occurs between the radio receiver assembly and multi-display controller sub-assembly, this DTCs will be stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1577 | GVIF Disconnected (from EMV/MM Integrated Device to RSE) | GVIF disconnected (from radio receiver assembly to multi-display controller sub-assembly) |
·
Harness and connector (GVIF cable)
·
Multi-display controller sub-assembly
·
Radio receiver assembly |
Navigation System | A |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION
Pre-procedure1
Clear the DTCs.
Turn the ignition switch off.
Procedure1
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Disconnect the I138 radio receiver assembly connector.
Disconnect the Q65 multi-display controller sub-assembly.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I138,Q65)Location & Routingewd_type=routing;type=c,c;code=I138,Q65 Click Connector(Q65)Seat>Floor Wire>Multi-Display Controllerewd_type=component;type=c;code=Q65;pinno=2,1,3 |
||
| I138-2 (GVI+) - Q65-2 (GVO+) | Always | Below 1 Ω |
| I138-1 (GVI-) - Q65-1 (GVO-) | Always | Below 1 Ω |
| I138-3 (GVG2) -Q65-3 (GVG2) | Always | Below 1 Ω |
| I138-2 (GVI+) - Body ground | Always | 10 kΩ or higher |
| I138-1 (GVI-) - Body ground | Always | 10 kΩ or higher |
| I138-3 (GVG2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Pre-procedure1
Replace the multi-display controller sub-assembly with a new or known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT ECU>REMOVAL
Clear the DTCs.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch off.
Procedure1
Recheck for DTCs and check that no DTCs are output.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
No DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio Receiver Type)>REMOVAL