| *1 | FRONT HOUSING | *2 | VANE PUMP PLATE |
| ● | Non-reusable part | - | - |
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not over tighten it.
44310 1.SECURE VANE PUMP ASSEMBLY
Using a SST, secure the vane pump assembly.
Remove and install SST for use in securing as necessary.
44337 2.REMOVE POWER STEERING SUCTION PORT UNION
3.REMOVE REAR HOUSING
| *a | Protective Tape | - | - |
Remove the 4 bolts and rear housing from the front housing.
Remove the O-ring from the rear housing.
Be careful not to damage the rear housing.
44303A 4.REMOVE VANE PUMP SHAFT WITH VANE PUMP PULLEY
Using 2 screwdrivers, remove the vane pump shaft snap ring from the vane pump shaft.
Remove the vane pump shaft with vane pump pulley.
Be careful not to drop or damage the vane pump shaft with vane pump pulley. If it is damaged, replace the vane pump assembly.
5.REMOVE VANE PUMP ROTOR
Remove the 10 vane pump plates from the vane pump rotor.
Be careful not to drop the vane pump plates.
Remove the vane pump rotor from the front housing.
6.REMOVE VANE PUMP CAM RING
7.REMOVE FRONT VANE PUMP SIDE PLATE
| *a | Protective Tape | - | - |
Remove the front vane pump side plate from the front housing.
Remove the O-ring from the front vane pump side plate.
Tape the screwdriver tip before use.
Remove the O-ring from the front housing.
8.REMOVE VANE PUMP HOUSING OIL SEAL
| *a | Protective Tape | - | - |
Using a screwdriver and piece of cloth, pry out the oil seal.
Be careful not to damage the front housing.