The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during spark plug removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
11209 1.REMOVE V-BANK COVER SUB-ASSEMBLY
82121 2.DISCONNECT ENGINE WIRE
16288 3.DISCONNECT NO.4 WATER BY-PASS PIPE
12266B 4.DISCONNECT NO.1 VENTILATION PRESSURE SENSOR HOSE
17650G 5.DISCONNECT PURGE VSV (DUTY VACUUM SWITCHING VALVE)
6.REMOVE BRACKET
19100P 8.REMOVE SPARK PLUG
|
|