| *1 | SNAP RING | *2 | INNER RACE |
| *3 | BALL | *4 | CAGE |
| *5 | FRONT DRIVE OUTBOARD JOINT ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
43448G 1.DISCONNECT FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP LH
Using a screwdriver, separate the front No. 2 axle inboard joint boot clamp LH as shown in the illustration.
43448F 2.DISCONNECT FRONT AXLE INBOARD JOINT BOOT CLAMP LH
Using pliers, grasp and move the front axle inboard joint boot clamp LH as shown in the illustration to disconnect it from the inboard joint boot.
3.DISCONNECT INBOARD JOINT BOOT
4.REMOVE INBOARD JOINT
| *a | Matchmark | *b | Outboard Joint Side |
Remove any old grease from the inboard joint.
Place matchmarks on the inboard joint and outboard joint shaft.
Do not use a punch to make the matchmark.
Remove the inboard joint from the outboard joint shaft.
Place matchmarks on the outboard joint shaft, inner race and cage.
Do not use a punch to make the matchmark.
Remove the 6 balls.
Slide the cage to the outboard joint side.
Using a snap ring expander, remove the snap ring.
Using a brass bar and hammer, remove the inner race.
Do not damage the inner race.
Remove the cage.
Remove the front No. 2 axle inboard joint boot setting clamp and front No. 1 axle inboard joint boot setting clamp, inboard joint boot from the outboard joint shaft.
43447F 5.DISCONNECT FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP LH
|
|
43447E 6.DISCONNECT FRONT AXLE OUTBOARD JOINT BOOT CLAMP LH
|
|
7.REMOVE OUTBOARD JOINT BOOT
Remove the front axle outboard joint boot clamp LH, outboard joint boot and front No. 2 axle outboard joint boot clamp LH from the front drive outboard joint assembly.
Remove any old grease from the front drive outboard joint assembly.
41336E 8.REMOVE FRONT DRIVE SHAFT DUST COVER LH
Using SST and a press, remove the front drive shaft dust cover LH from the front drive inboard joint assembly.
43502K 9.REMOVE FRONT AXLE HUB DUST SEAL LH
Using a screwdriver and hammer, remove the front axle hub dust seal LH from the front drive outboard joint assembly.
Do not damage the front drive outboard joint assembly.