| *1 | GENERATOR DRIVE END FRAME | *2 | GENERATOR WASHER |
| *3 | RETAINER PLATE | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
27310B 1.INSTALL GENERATOR DRIVE END FRAME BEARING
| *a | Tab | *b | Cutout |
Using SST and a press, install a new generator drive end frame bearing.
Fit the tabs of the retainer plate into the cutouts of the generator drive end frame to install the retainer plate.
Install the 4 screws.
27330 2.INSTALL GENERATOR ROTOR ASSEMBLY
Install the generator rotor assembly to the generator drive end frame.
Place a new generator washer on the generator rotor assembly.
Make sure to install the washer so that its cutout faces the bearing side, as the washer must be installed in a specific direction.
27360 3.INSTALL GENERATOR COIL ASSEMBLY
Using a 21 mm deep socket wrench and press, slowly press in the generator coil assembly.
Install the 4 bolts.
27370 4.INSTALL GENERATOR BRUSH HOLDER ASSEMBLY
| *a | Pin (1.0 mm) | - | - |
|
Pull out | - | - |
While pushing the 2 brushes into the generator brush holder assembly, insert a 1.0 mm (0.0394 in.) pin into the generator brush holder assembly hole.
Install the generator brush holder assembly to the generator coil assembly with the 2 screws.
Pull out the pin from the generator brush holder assembly hole.
27387B 5.INSTALL GENERATOR TERMINAL INSULATOR
27039 6.INSTALL GENERATOR REAR END COVER
27411 7.INSTALL GENERATOR PULLEY
| *a | Rotor Shaft | *b | Hold |
| *c | Turn | - | - |
Secure the generator drive end frame in a vise between aluminum plates.
Temporarily install the generator pulley by hand.
Install SST 1-A to the generator pulley shaft.
Install SST 1-B to SST 1-A.
Hold SST 1-A with a torque wrench and turn SST 1-B clockwise with the specified torque.
Make sure that SST is secured to the generator rotor shaft.
Insert SST 2 and attach it to the generator pulley nut.
| *a | Hold | *b | Turn |
Tighten the generator pulley nut by turning SST 1- A in the direction shown in the illustration.
Remove SST 2 from the generator assembly.
Turn SST 1-B in the direction shown in the illustration and remove SST 1-A and B.
Turn the generator pulley and check that the generator pulley moves smoothly.
Remove the generator drive end frame from the vise.