Home › Drivetrain › AJA0F (AUTOMATIC TRANSMISSION / TRANSAXLE) › SHIFT LEVER KNOB
RM38G0E _52 Drivetrain _100435 AJA0F AUTOMATIC TRANSMISSION / TRANSAXLE _0473273 SHIFT LEVER KNOB A

AJA0F AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LEVER KNOB  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
C456032N02
5.333,1.5 5.583,1.5 false 6,1.417 6.333,1.917 0.333,0.5 18 false 1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 SHIFT LEVER KNOB SUB-ASSEMBLY 33504F (Click here) - -

CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 33504F 1.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

a.
C456036C01
1.917,0.979 1.917,0.5 1.917,0.5 2,0.5 true 2.667,0.979 2.667,0.5 2.667,0.5 2.75,0.5 true 2,1.583 2.167,1.583 2.167,1.583 2.167,1.083 true 2.583,1.583 2.792,1.583 2.792,1.583 2.792,1.083 true 0.417,0.219 0.667,0.635 0.25,0.417 18 false i 3.802,0.219 4.052,0.635 0.25,0.417 18 false ii 0.073,2.76 0.323,3.177 0.25,0.417 18 false iii 3.771,2.792 4.021,3.208 0.25,0.417 18 false iv 1.667,0.333 1.833,0.5 0.167,0.167 10 false *a 2.333,0.333 2.5,0.5 0.167,0.167 10 false *b 2.042,0.417 2.208,0.583 0.167,0.167 10 false *c 2.771,0.417 2.938,0.583 0.167,0.167 10 false *c 1.833,1.5 2,1.667 0.167,0.167 10 false *d 2.417,1.5 2.583,1.667 0.167,0.167 10 false *d
*a Correct *b Incorrect
*c Clip *d Claw
V113147

Pull Upward - -


i.

Check that the clip is securely installed to the shift lever knob sub-assembly.

NOTICE:

If the clip is not installed on the inside of the shift lever knob sub-assembly claw, the shift lever knob sub-assembly may fall off.



ii.

Install the shift lever knob sub-assembly to the floor shift lever assembly.

NOTICE:

Check that the clip is positioned as shown in the illustration.



iii.

Pull the shift lever knob sub-assembly upward by hand and check that it is not coming off.


iv.

Engage the claw to connect the shifting hole cover sub-assembly as shown in the illustration.

NOTICE:

Make sure that the shifting hole cover sub-assembly does not twist after installing the shift lever knob sub-assembly.