| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT UPPER SUSPENSION ARM BUSH LH | 48632B | ( ) |
- | - |
| 2 | FRONT UPPER BALL JOINT DUST COVER LH | 43324C | ( ) |
- | - |
| *1 | FRONT UPPER SUSPENSION ARM ASSEMBLY LH | *2 | DUST COVER SET RING |
|
Do not apply lubricants to the threaded parts | ● | Non-reusable part |
48632B 1.REMOVE FRONT UPPER SUSPENSION ARM BUSH LH
| *1 | Front Upper Suspension Arm Bush LH | - | - |
Using a hammer and chisel, strike and bend the entire flange of the front upper suspension arm bush LH as shown in the illustration.
Using SST and a press, press out the front upper suspension arm bush LH.
Remove the rear side bush using the same procedure as for the front side.
43324C 2.REMOVE FRONT UPPER BALL JOINT DUST COVER LH
Using snap ring expander, remove the dust cover set ring and front upper ball joint dust cover from the front upper suspension arm assembly LH.
Do not damage the upper ball joint dust cover.
If the upper ball joint dust cover is damaged, replace it.