| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT UPPER BALL JOINT DUST COVER LH | 43324C | ( ) |
- | - |
| 2 | FRONT UPPER SUSPENSION ARM BUSH LH | 48632B | ( ) |
- | - |
| *1 | FRONT UPPER SUSPENSION ARM ASSEMBLY LH | *2 | DUST COVER SET RING |
|
MP Grease |
|
Do not apply lubricants to the threaded parts |
| ● | Non-reusable part | - | - |
43324C 1.INSTALL FRONT UPPER BALL JOINT DUST COVER LH
| *a | MP grease | - | - |
Pack the front upper arm ball joint with MP grease.
4.0 g (0.141 oz.)
Apply MP grease to the locations shown in the illustration.
Do not apply MP grease to the tapered or threaded parts of the ball joint.
Install a new front upper ball joint dust cover LH to the front upper suspension arm assembly LH.
Using snap ring expander, install a new dust cover set ring.
Make sure the set ring is securely installed in the groove.
48632B 2.INSTALL FRONT UPPER SUSPENSION ARM BUSH LH
Using SST and a press, press in a new front upper suspension arm bush LH.
Press in the rear side bush using the same procedure as for the front side.