Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type, for 12.3 Inch Display)
RM38G0E _56 Audio / Visual / Telematics _100606 AUDIO / VIDEO _0467496 AUDIO AND VISUAL SYSTEM(for Radio and Display Type, for 12.3 Inch Display) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type, for 12.3 Inch Display)  B1577  GVIF Disconnected (from EMV/MM Integrated Device to RSE)  


DESCRIPTION

The radio receiver assembly and multi-display controller sub-assembly are connected by GVIF cable.

When a GVIF cable error occurs between the radio receiver assembly and multi-display controller sub-assembly, this DTCs will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B1577 GVIF Disconnected (from EMV/MM Integrated Device to RSE) GVIF disconnected (from radio receiver assembly to multi-display controller sub-assembly)
·

Harness and connector (GVIF cable)

·

Multi-display controller sub-assembly

·

Radio receiver assembly


Navigation System A

WIRING DIAGRAM

E362110E80
1.531,2.354 1.99,2.521 0.458,0.167 10 false Q65 5,2.354 5.354,2.51 0.354,0.156 10 false I138 5.01,2.521 6.719,2.719 1.708,0.198 10 false Radio Receiver Assembly 1.521,2.51 2.927,2.917 1.406,0.406 10 false Multi-display Controller Sub-assembly 5.073,0.906 5.531,1.104 0.458,0.198 10 false GVI+ 2.219,1.469 2.677,1.667 0.458,0.198 10 false GVO- 2.188,2.063 2.646,2.26 0.458,0.198 10 false GVG2 2.188,0.906 2.646,1.104 0.458,0.198 10 false GVO+ 5.073,1.458 5.531,1.656 0.458,0.198 10 false GVI- 5.063,2.063 5.521,2.26 0.458,0.198 10 false GVG2 2.698,1.365 2.854,1.563 0.156,0.198 10 false 1 4.844,0.802 5,1 0.156,0.198 10 false 2 4.833,1.354 4.99,1.552 0.156,0.198 10 false 1 2.698,0.781 2.854,0.979 0.156,0.198 10 false 2 2.708,1.99 2.865,2.188 0.156,0.198 10 false 3 4.854,1.969 5.01,2.167 0.156,0.198 10 false 3 1.229,3.146 2.177,3.313 0.948,0.167 10 false : GVIF Cable 2.5,3.135 3.448,3.302 0.948,0.167 10 false *: Shielded 3.719,1.938 3.906,2.167 0.188,0.229 10 false *

CAUTION / NOTICE / HINT

HINT:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio and Display Type, for 12.3 Inch Display)>PRECAUTION


PROCEDURE

1.CHECK DTC

Pre-procedure1

a.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Turn the ignition switch off.


Procedure1

c.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Result Proceed to
DTCs are not output A
DTCs are output B


Post-procedure1

d.

None



A

B

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY)

Pre-procedure1

a.

Disconnect the I138 radio receiver assembly connector.


b.

Disconnect the Q65 multi-display controller sub-assembly.


Procedure1

c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(I138,Q65)Location & Routing

Click Connector(I138)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Radio Receiver Assembly

Click Connector(Q65)Seat>Floor Wire>Multi-Display Controller

I138-2 (GVI+) - Q65-2 (GVO+) Always Below 1 Ω
I138-1 (GVI-) - Q65-1 (GVO-) Always Below 1 Ω
I138-3 (GVG2) - Q65-3 (GVG2) Always Below 1 Ω
I138-2 (GVI+) - Body ground Always 10 kΩ or higher
I138-1 (GVI-) - Body ground Always 10 kΩ or higher
I138-3 (GVG2) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG


Post-procedure1

d.

None



OK

3.CHECK MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY

Pre-procedure1

a.

Replace the multi-display controller sub-assembly with a new or known good one.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT ECU>REMOVAL


b.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Turn the ignition switch off.


Procedure1

d.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Result Proceed to
DTCs are not output A
DTCs are output B


Post-procedure1

e.

None



A

END (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY IS DEFECTIVE)

B