This DTC is stored when a malfunction occurs in a connected device.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1585 | USB Device Malfunction | When any of the following conditions is met:
·
A non mass-storage class or incompatible protocol USB device connected
·
USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT) connected
·
"iPod" malfunction
·
"iPod" with unsupported firmware connected
·
Unsupported "iPod" model connected |
·
USB device or "iPod"
·
Radio receiver assembly |
Navigation System | A |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Pre-procedure1
Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
Turn the ignition switch off.
When this DTC has been stored, it is necessary to turn the ignition switch to off to make it possible for the vehicle to recognize a new device when it is connected.
Turn the ignition switch to ACC.
Procedure1
Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
Refer to System Description for compatible formats and versions.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>SYSTEM DESCRIPTION
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Clear the DTCs.
Procedure1
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
Post-procedure1
None
A
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio Receiver Type)>REMOVAL