| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 1 EMISSION CONTROL VALVE SET | 25701B | ( ) |
- | - |
| 2 | AIR TUBE | 17361 | ( ) |
- | - |
| *1 | NO. 2 AIR TUBE GASKET | *2 | AIR TUBE ASSEMBLY |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
25701B 1.INSTALL NO. 1 EMISSION CONTROL VALVE SET
| *a | Paint Mark | *b | Sensing Hose |
| *c | 60° | - | - |
Install the No. 1 emission control valve set with 3 bolts.
Connect the air tube assembly and slide the hose clip to secure it.
Align the paint mark of air tube assembly with sensing hose.
Align the hose and the hose clip at the locations shown in the illustration and install them.
Connect the connector.
17361 2.INSTALL AIR TUBE
Install 2 new No. 2 air tube gaskets to the air tube as shown in the illustration.
Install the air tube with the 2 bolts and 2 nuts.
Be careful not to damage the installation surface of the gaskets.