Home › Engine / Hybrid System › V35A-FTS (COOLING) › RADIATOR
RM38G0E _51 Engine / Hybrid System _101529 V35A-FTS COOLING _0470502 RADIATOR G

V35A-FTS COOLING  RADIATOR  INSPECTION  


PROCEDURE

Hide 16210 1.INSPECT FLUID COUPLING ASSEMBLY

a.

Remove the fluid coupling assembly with fan.

Click hereEngine / Hybrid System>V35A-FTS (COOLING)>WATER PUMP>REMOVAL


b.
A487197

Remove the 4 nuts and fluid coupling assembly.


c.
A487198

Turn the fluid coupling assembly and check that the bearing moves smoothly and quietly.

If necessary, replace the fluid coupling assembly.


d.

Check the fluid coupling assembly for damage or silicon oil leaks.

If necessary, replace the fluid coupling assembly.


e.
A489718C01
0.729,1.021 0.99,1.219 0.26,0.198 2,0.927 2.25,0.5 2.25,0.5 2.5,0.5 true 1.427,0.927 1.167,0.5 1.167,0.5 0.917,0.5 true 2.563,0.417 3.031,0.635 0.469,0.219 10 false EFC+ 0.51,0.417 0.979,0.635 0.469,0.219 10 false GDFC 0.146,0.115 0.427,0.313 0.281,0.198 10 false *a 0.771,1.031 1,1.219 0.229,0.188 10 false C8
*a Component without harness connected
(Fluid Coupling Assembly)


Measure the resistance according to the value(s) in the table below.

Tester Connection Condition Specified Condition

Click Location & Routing(C8)Location & Routing

Click Connector(C8)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>Fluid Coupling Assembly

C8-1(EFC+) - C8-3(GDFC) 20 °C (68 °F) 7.05 to 8.61 Ω


f.

Install the fluid coupling assembly with the 4 nuts.

Torque:
10.0 N*m (102 kgf*cm, 7 ft.*lbf)


g.

Install the fluid coupling assembly with fan.

Click hereEngine / Hybrid System>V35A-FTS (COOLING)>WATER PUMP>INSTALLATION