| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | MAGNET CLUTCH ASSEMBLY | 88410 | ( ) |
- | - |
| 2 | MAGNET CLUTCH CLEARANCE | - | ( ) |
- | - |
| 3 | NO. 2 COOLER COMPRESSOR BRACKET | 88849 | - | - | - |
| *1 | MAGNET CLUTCH HUB | *2 | MAGNET CLUTCH WASHER |
| *3 | MAGNET CLUTCH ROTOR | *4 | MAGNET CLUTCH STATOR |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
88410 1.INSTALL MAGNET CLUTCH ASSEMBLY
| *a | SST | *b | Chamfered Side |
| *c | Inside | *d | Outside |
Install the magnet clutch assembly using the following procedure.
1. Clamp the cooler compressor assembly in a vise between aluminum plates.
2. Install the magnet clutch stator with the parts aligned as shown in the illustration.
3. Using SST, install a new snap ring with the chamfered side facing outward.
When installing the snap ring, do not widen it excessively.
4. Using SST, install the magnet clutch rotor and a new snap ring with the chamfered side facing outward.
Do not damage the seal cover of the bearing when installing the snap ring.
When installing the snap ring, do not widen it excessively.
5. Install the magnet clutch washer(s) and magnet clutch hub.
Do not change the combination of the magnet clutch washer(s) used before disassembly.
6. Using SST, hold the magnet clutch hub and install the bolt.
Make sure that there is no foreign matter or oil on the compressor shaft, bolt and magnet clutch hub.
2.INSPECT MAGNET CLUTCH CLEARANCE
Inspect the magnet clutch clearance using the following procedure.
1. Set a dial indicator to the magnet clutch hub.
2. Connect a battery positive lead to terminal 1 of the magnet clutch connector and a negative lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.
0.35 to 0.60 mm (0.0138 to 0.0236 in.)
Adjustment should be performed with 3 or fewer magnet clutch washers.
If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using magnet clutch washers to obtain the standard clearance.
3. Remove the compressor with magnet clutch from the vise.
88849 3.INSTALL NO. 2 COOLER COMPRESSOR BRACKET