| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FAN SHROUD | 16711 | - | - | - |
| *1 | HEATER WATER PIPE B | *2 | DUST COVER |
| *3 | IDLE PULLEY SUB-ASSEMBLY | *4 | IDLE PULLEY COLLAR |
16711 1.REMOVE FAN SHROUD
82121 2.DISCONNECT ENGINE WIRE
| *a | Bolt (A) | *b | Bolt (B) |
| *c | Clamp | *d | Guide |
87245J 3.DISCONNECT INLET HEATER WATER HOSE J
Using pliers, grip the claws of the clip and slide the clip to disconnect the inlet heater water hose J.
Do not apply excessive force to the inlet heater water hose J.
Prepare a drain pan or cloth in case the coolant leaks.
87255C 4.DISCONNECT REAR INLET HEATER WATER HOSE C
Using pliers, grip the claws of the clip and slide the clip to disconnect the rear inlet heater water hose C.
Do not apply excessive force to the rear inlet heater water hose C.
Prepare a drain pan or cloth in case the coolant leaks.
87120G 5.REMOVE VISCOUS HEATER WITH MAGNET CLUTCH ASSEMBLY
Remove the 2 bolts and guide.
Remove the 2 bolts and viscous heater with magnet clutch assembly.
Using pliers, grip the claws of the 2 clips and slide the 2 clips to remove the heater water pipe B.
16604C 6.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
| *1 | DUST COVER | *2 | IDLE PULLEY SUB-ASSEMBLY |
| *3 | IDLE PULLEY COLLAR | - | - |
16630H 7.REMOVE IDLER PULLEY ASSEMBLY
16604C 8.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
| *1 | DUST COVER | *2 | IDLE PULLEY SUB-ASSEMBLY |
| *3 | IDLE PULLEY COLLAR | - | - |
16630J 9.REMOVE NO. 2 IDLER PULLEY ASSEMBLY