Home › Engine / Hybrid System › F33A-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ DPF) › from 2021.07
RM38G0E _51 Engine / Hybrid System _106329 F33A-FTV ENGINE CONTROL _0484871 ECD SYSTEM(w/ DPF) C

F33A-FTV ENGINE CONTROL  ECD SYSTEM(w/ DPF)  P202A19  Reductant Tank Heater Control Circuit Performance Circuit Current Above Threshold  P20B919  Reductant Heater "A" Control Circuit Performance Circuit Current Above Threshold  


DESCRIPTION

Refer to DTC P202A12.

Click hereEngine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>P202A12

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note
P202A19 Reductant Tank Heater Control Circuit Performance Circuit Current Above Threshold When the tank heater is operating (temperature sensor value is equal to or less than a fixed value), overcurrent is detected 1 time.
(1 trip detection logic)
Urea pump Comes on SAE Code: P209F
P20B919 Reductant Heater "A" Control Circuit Performance Circuit Current Above Threshold When the urea tube with heater is operating (ambient temperature sensor value is equal to or less than a fixed value), overcurrent is detected 1 time.
(1 trip detection logic)
Urea tube with heater assembly Comes on SAE Code: P20BA

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P202A19 Reductant Tank Heater (Active Test)
P20B919 Reductant Pipe Heater (Active Test)

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK DTC OUTPUT
a.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

b.

Read the DTCs.

Result:
Result Proceed to
DTC P202A19 or P20B919 is output A
DTC P202A19 or P20B919 and other DTCs are output* B


HINT:

*: If any other DTCs (CAN communication malfunctions or open/short circuits) are output, perform troubleshooting for those DTCs first.




A

2.CHECK AROUND BOTTOM OF VEHICLE

B

GO TO DTC CHART

2.CHECK AROUND BOTTOM OF VEHICLE
a.

Check around the bottom of the vehicle.

HINT:

If the urea solution dries on an object, deposition occurs and leaves behind a white powder.


Area to check:

·

Areas connecting the urea pump and urea injector assembly.

·

Perforations in the urea tank sub-assembly.

·

Connectors not connected properly.



b.

Repair any trouble areas.


Result:
Proceed to
NEXT



NEXT

3.PERFORM ACTIVE TEST USING GTS (REDUCTANT PURGE)
3.PERFORM ACTIVE TEST USING GTS (REDUCTANT PURGE)
a.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 372

b.

Turn the ignition switch off and wait for at least 30 seconds.


c.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Pump Check (Backward).

Powertrain > Engine > Active Test
Tester Display
Reductant Pump Check (Backward)
50004 372 85

d.

Perform the Active Test.


e.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Purge.

Powertrain > Engine > Active Test
Tester Display
Reductant Purge
50004 372 86

f.

Perform the Active Test.

HINT:

Perform the Reductant Purge to draw the urea solution back into the urea tank sub-assembly from the urea injector assembly.



Result:
Proceed to
NEXT



NEXT

4.CHECK DTC OUTPUT (DTC P202A19)
4.CHECK DTC OUTPUT (DTC P202A19)
a.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Tank Heater.

Powertrain > Engine > Active Test
Tester Display
Reductant Tank Heater
50004 372 88

b.

Perform the Active Test.


c.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

d.

Read the DTCs.


Result:
Result Proceed to
DTC P202A19 is output A
No DTC is output B



A

5.REPLACE UREA PUMP

B

6.CHECK DTC OUTPUT (DTC P20B919)
5.REPLACE UREA PUMP

Result:
Proceed to
NEXT



NEXT

8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
6.CHECK DTC OUTPUT (DTC P20B919)
a.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Pipe Heater.

Powertrain > Engine > Active Test
Tester Display
Reductant Pipe Heater
50004 372 87

b.

Perform the Active Test.


c.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

d.

Read the DTCs.


Result:
Result Proceed to
DTC P20B919 is output A
No DTC is output B



A

7.REPLACE UREA TUBE WITH HEATER ASSEMBLY

B

8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
7.REPLACE UREA TUBE WITH HEATER ASSEMBLY
a.

Replace the urea tube with heater assembly.


Result:
Proceed to
NEXT



NEXT

8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 372

b.

Turn the ignition switch off and wait for at least 30 seconds.


c.

Turn the ignition switch to ON and turn the GTS on.


d.

Using the GTS, perform the following Active Tests.

·

To check DTC P202A19:

Enter the following menus: Powertrain / Engine / Active Test / Reductant Tank Heater.


Powertrain > Engine > Active Test
Tester Display
Reductant Tank Heater
50004 372 88
·

To check DTC P20B919:

Enter the following menus: Powertrain / Engine / Active Test / Reductant Pipe Heater.


Powertrain > Engine > Active Test
Tester Display
Reductant Pipe Heater
50004 372 87

e.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

f.

Confirm that the DTC is not output again.


Result:
Proceed to
NEXT



NEXT

END