The urea pump is a bottom entry type in-tank pump installed to the bottom of the urea tank assembly.
It contains a UTLC sensor* that uses ultrasonic waves, a urea pump, a urea tank heater and a urea pressure sensor. It is integrated with the urea pump control ECU and provides the following functionality.
The UTLC sensor uses ultrasonic waves to send the temperature, level and quality (concentration) of urea as status signals to the urea pump control ECU using SENT communication.
A pump to pressurize and supply the urea solution
A heating function to thaw the urea solution and to warm it up to prevent it from freezing
A level gauge to measure the urea solution amount in the tank
A urea solution quality check to detect a decrease in the concentration of urea in the tank
A filter for collecting the foreign matter in the urea solution tank
Diagnosis function integrated with the urea pump control ECU to detect malfunctions in sensors and actuators
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Note |
|---|---|---|---|---|---|
| P203A96 | Reductant Level Sensor "A" Circuit Component Internal Failure | An internal malfunction occurs in the urea solution level sensor for 3 seconds or more. (1 trip detection logic) |
Urea pump | Comes on | SAE Code: P203A |
| P204A12 | Reductant Pressure Sensor Circuit High Circuit Short to Battery | An open or short circuit occurs in the pressure sensor circuit for 3 seconds or more. (1 trip detection logic) |
Urea pump | Comes on | SAE Code: P204D |
| P204A14 | Reductant Pressure Sensor Circuit Low Circuit Short to Ground or Open | An open or short circuit occurs in the pressure sensor circuit for 3 seconds or more. (1 trip detection logic) |
Urea pump | Comes on | SAE Code: P204C |
| P205A11 | Reductant Tank Temperature Sensor Circuit Low Circuit Short to Ground | An open or short circuit occurs in the temperature sensor circuit for 3 seconds or more. (1 trip detection logic) |
Urea pump | Comes on | SAE Code: P205C |
| P205A15 | Reductant Tank Temperature Sensor Circuit High Circuit Short to Battery or Open | An open or short circuit occurs in the temperature sensor circuit for 3 seconds or more. (1 trip detection logic) |
Urea pump | Comes on | SAE Code: P205D |
| P206A87 | Reductant Quality Sensor Circuit Missing Message | A malfunction occurs during urea pump assembly (urea pump control ECU integrated urea pump) communication with the UTLC sensor for 3 seconds or more. (1 trip detection logic) |
Urea pump | Comes on | SAE Code: P206A |
| P206A96 | Reductant Quality Sensor Circuit Component Internal Failure | An internal malfunction occurs in the urea solution level sensor when the ignition switch is turned to ON. (1 trip detection logic) |
Urea pump | Comes on | SAE Code: P206A |
| P208A12 | Reductant Pump "A" Control Circuit High Circuit Short to Battery | When the urea pump motor is operating, an open or short circuit occurs in the urea pump motor circuit for 3 seconds or more. (1 trip detection logic) |
Urea pump | Comes on | SAE Code: P208D |
| P208A14 | Reductant Pump "A" Control Circuit Low Circuit Short to Ground or Open | When the urea pump motor is operating, an open or short circuit occurs in the urea pump motor circuit for 3 seconds or more. (1 trip detection logic) |
Urea pump | Comes on | SAE Code: P208C |
| DTC No. | Data List |
|---|---|
| P203A96 | - |
| P204A12 P204A14 |
Reductant Pressure |
| P205A11 P205A15 |
Reductant Temperature |
| P206A87 | - |
| P206A96 | - |
| P208A12 P208A14 |
Reductant Pump Speed |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P203A96 | Ignition switch to ON for 3 seconds or more |
| P204A12 P204A14 |
|
| P205A11 P205A15 |
|
| P206A87 | |
| P206A96 | |
| P208A12 P208A14 |
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Replace the urea pump.
Click hereEngine / Hybrid System>F33A-FTV (EMISSION CONTROL)>UREA PUMP>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON and wait for 3 seconds or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT