Home › Engine / Hybrid System › F33A-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ DPF) › from 2021.07
RM38G0E _51 Engine / Hybrid System _106329 F33A-FTV ENGINE CONTROL _0484871 ECD SYSTEM(w/ DPF) C

F33A-FTV ENGINE CONTROL  ECD SYSTEM(w/ DPF)  P204712  Reductant Injection Valve Circuit High Bank 1 Unit 1 Circuit Short to Battery  P204714  Reductant Injection Valve Circuit Low Bank 1 Unit 1 Circuit Short to Ground or Open  


DESCRIPTION

The urea injector opens the needle valve and injects urea solution according to operation signals sent by the urea pump control ECU (urea pump).

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note
P204712 Reductant Injection Valve Circuit High Bank 1 Unit 1 Circuit Short to Battery When the urea injector is operating, an open or short circuit occurs in the urea injector circuit for 5 seconds or more.
(1 trip detection logic)
·

Open or short in urea injector assembly circuit

·

Urea injector assembly

·

Urea pump


Comes on SAE Code: P2049
P204714 Reductant Injection Valve Circuit Low Bank 1 Unit 1 Circuit Short to Ground or Open When the urea injector is operating, an open or short circuit occurs in the urea injector circuit for 5 seconds or more.
(1 trip detection logic)
·

Open or short in urea injector assembly circuit

·

Urea injector assembly

·

Urea pump


Comes on SAE Code: P2048

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P204712
P204714
Reductant Injection Valve (Active Test)

WIRING DIAGRAM

A383041E14
1.229,1.25 1.385,1.448 0.156,0.198 10 false 1 2.563,1.25 2.719,1.448 0.156,0.198 10 false 2 1.385,1.75 2,1.948 0.615,0.198 10 false C141 1.385,1.938 4.198,2.333 2.813,0.396 10 false Urea Injector Assembly 5.438,0.615 5.594,0.813 0.156,0.198 10 false 4 5.469,1.24 5.625,1.438 0.156,0.198 10 false 2 5.688,0.74 6.302,0.938 0.615,0.198 10 false UIV+ 5.677,1.375 6.292,1.573 0.615,0.198 10 false UIV- 5.385,1.906 5.698,2.104 0.313,0.198 10 false x2 5.677,2.115 7.042,2.531 1.365,0.417 10 false Urea Pump 1.469,1.25 1.833,1.448 0.365,0.198 10 false #1U 2.25,1.25 2.615,1.448 0.365,0.198 10 false +B

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.INSPECT UREA INJECTOR ASSEMBLY
a.

Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (UREA INJECTOR ASSEMBLY - UREA PUMP)

NG

7.REPLACE UREA INJECTOR ASSEMBLY
2.CHECK HARNESS AND CONNECTOR (UREA INJECTOR ASSEMBLY - UREA PUMP)
a.

Disconnect the urea injector assembly connector.


b.

Disconnect the urea pump connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(C141,x2)Location & Routing

Click Connector(C141)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>Urea Injector Assembly

Click Connector(x2)Body>Urea Tank Harness>Urea Pump

C141-2 (+B) - x2-2 (UIV-) Always Below 1 Ω
C141-1 (#1U) - x2-4 (UIV+) Always Below 1 Ω
C141-2 (+B) or x2-2 (UIV-) - Body ground and other terminals Always 10 kΩ or higher
C141-1 (#1U) or x2-4 (UIV+) - Body ground and other terminals Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.CHECK DTC OUTPUT

NG

6.REPAIR OR REPLACE HARNESS OR CONNECTOR
3.CHECK DTC OUTPUT
a.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 372

b.

Turn the ignition switch off and wait for 30 seconds or more.


c.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Injection Valve.

Powertrain > Engine > Active Test
Tester Display
Reductant Injection Valve
50004 372 82

d.

Perform the Active Test.


e.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

f.

Read the DTCs.


Result:
Result Proceed to
DTC P204712 or P204714 is output A
No DTC is output B



A

4.REPLACE UREA PUMP

B

END

4.REPLACE UREA PUMP

Result:
Proceed to
NEXT



NEXT

5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 372

b.

Turn the ignition switch off and wait for 30 seconds or more.


c.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Injection Valve.

Powertrain > Engine > Active Test
Tester Display
Reductant Injection Valve
50004 372 82

d.

Perform the Active Test.


e.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

f.

Confirm that the DTC is not output again.


Result:
Proceed to
NEXT



NEXT

END

6.REPAIR OR REPLACE HARNESS OR CONNECTOR
a.

Repair or replace the harness or connector.


Result:
Proceed to
NEXT



NEXT

5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
7.REPLACE UREA INJECTOR ASSEMBLY
a.

Replace the urea injector assembly.

Click hereEngine / Hybrid System>F33A-FTV (EMISSION CONTROL)>UREA INJECTOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED