Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for Toyota Connected Services) › from 2021.07
RM38G0E _56 Audio / Visual / Telematics _100608 TELEMATICS _0484974 TELEMATICS SYSTEM(for Toyota Connected Services) C

TELEMATICS  TELEMATICS SYSTEM(for Toyota Connected Services)  B153711  Telephone Sub Antenna Circuit Short to Ground  B153713  Telephone Sub Antenna Circuit Open  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation antenna assembly circuit.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B153711 Telephone Sub Antenna Circuit Short to Ground Navigation antenna assembly impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON
(Short circuit)
·

Telephone transceiver assembly

·

Navigation antenna assembly

·

Antenna cord sub-assembly


Telematics A
B153713 Telephone Sub Antenna Circuit Open Navigation antenna assembly impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON
(Open circuit)
·

Telephone transceiver assembly

·

Navigation antenna assembly

·

Antenna cord sub-assembly


Telematics A

WIRING DIAGRAM

E364289E46
2.063,2.406 3.271,2.823 1.208,0.417 10 false Navigation Antenna Assembly 3.708,2.667 4.625,3.031 0.917,0.365 10 false Antenna Cord Sub-assembly 4.99,2.563 6.385,2.969 1.396,0.406 10 false Telephone Transceiver Assembly 4.823,1.438 4.938,1.604 0.115,0.167 10 false B 3.354,1.427 3.469,1.594 0.115,0.167 10 false A 3.365,1.969 3.479,2.135 0.115,0.167 10 false A 4.823,1.969 4.938,2.135 0.115,0.167 10 false B 4.833,1.229 4.948,1.396 0.115,0.167 10 false 1 4.781,1.76 4.979,1.927 0.198,0.167 10 false 1a 3.365,1.229 3.479,1.396 0.115,0.167 10 false 4 3.333,1.76 3.531,1.927 0.198,0.167 10 false 4a 5.156,1.448 5.646,1.677 0.49,0.229 10 false ANT3

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for Toyota Connected Services)>PRECAUTION

·

When replacing the telephone transceiver assembly, make sure to replace it with a new one.



PROCEDURE

1.CHECK DTC

Pre-procedure1

a.

Turn the ignition switch to ON and wait for 10 seconds or more.


b.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 459

Procedure1

c.

Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 459
Result:
Result Proceed to
DTCs are output A
DTCs are not output B



Post-procedure1

d.

None



A

B

2.INSPECT NAVIGATION ANTENNA ASSEMBLY
2.INSPECT NAVIGATION ANTENNA ASSEMBLY

OK

3.INSPECT ANTENNA CORD SUB-ASSEMBLY

NG

3.INSPECT ANTENNA CORD SUB-ASSEMBLY

Pre-procedure1

a.
E427068C04
1.479,0.115 1.844,0.385 0.365,0.271 1.5,1.698 1.865,1.969 0.365,0.271 2.146,0.844 2.5,0.333 2.5,0.333 2.698,0.333 true 1.833,2.771 2.188,2.26 2.188,2.26 2.385,2.26 true 1.021,2.604 1.208,2.604 1.208,2.604 1.646,2.781 true 0.125,0.135 0.438,0.333 0.313,0.198 10 false *a 2.771,0.25 3.083,0.448 0.313,0.198 10 false 4a 2.448,2.188 2.76,2.385 0.313,0.198 10 false 1a 0.635,2.521 1.031,2.813 0.396,0.292 10 false ANT3 1.635,0.167 1.948,0.365 0.313,0.198 10 false A 1.625,1.76 1.938,1.958 0.313,0.198 10 false B 0.167,1.792 0.479,1.99 0.313,0.198 10 false *b
*a Front view of wire harness connector
(to Navigation Antenna Assembly)
*b Front view of wire harness connector
(to Telephone Transceiver Assembly)


Disconnect the antenna connector from the navigation antenna assembly.


b.

Disconnect the antenna connector from the telephone transceiver assembly.


Procedure1

c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-4 - B-1 (ANT3) Always Below 1 Ω
A-4a - B-1a Always Below 1 Ω
A-4 - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

d.

None



OK

4.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY

NG

4.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
a.

Replace the telephone transceiver assembly with a new one.

HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL



Result:
Proceed to
NEXT



NEXT