Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for Toyota Connected Services) › from 2021.07
RM38G0E _56 Audio / Visual / Telematics _100608 TELEMATICS _0484974 TELEMATICS SYSTEM(for Toyota Connected Services) C

TELEMATICS  TELEMATICS SYSTEM(for Toyota Connected Services)  B15C464  Airbag Signal Signal Plausibility Failure  


DESCRIPTION

If the telephone transceiver assembly detects an error in communication between the telephone transceiver assembly and the airbag sensor with ECU assembly as a result of the telephone transceiver assembly self check, this DTC will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B15C464 Airbag Signal Signal Plausibility Failure Telephone transceiver assembly detects an error in signals from airbag sensor with ECU assembly when ignition switch is ON.
·

Airbag system

·

Harness or connector

·

Airbag sensor with ECU assembly

·

Telephone transceiver assembly


Telematics B

WIRING DIAGRAM

E473253E01
2.531,1.125 2.833,1.302 0.302,0.177 10 false 23 1.958,1.125 2.479,1.323 0.521,0.198 10 false GSW3 4.896,1.125 5.406,1.313 0.51,0.188 10 false GSW 4.604,1.125 4.875,1.333 0.271,0.208 10 false 13 1.167,2.073 1.49,2.25 0.323,0.177 10 false I24 1.177,2.24 2.698,2.635 1.521,0.396 10 false Airbag Sensor with ECU Assembly 4.74,2.052 5.292,2.281 0.552,0.229 10 false I55 4.719,2.229 6.135,2.615 1.417,0.385 10 false Telephone Transceiver Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for Toyota Connected Services)>PRECAUTION

·

The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the Precaution in the SRS.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When replacing the telephone transceiver assembly, make sure to replace it with a new one.



PROCEDURE

1.CHECK DTC (AIRBAG SYSTEM)

Pre-procedure1

a.

Turn the ignition switch to ON and wait for 10 seconds.


Procedure1

b.

Check the DTC of "AIRBAG SYSTEM".

Body Electrical > SRS Airbag > Trouble Codes
50001 444
Result:
Result Proceed to
DTCs are not output A
DTCs are output B



Post-procedure1

c.

None



A

2.CHECK DTC

B

2.CHECK DTC

Pre-procedure1

a.

Turn the ignition switch to ON and wait for 10 seconds or more.


Procedure1

b.

Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 459
Result:
Result Proceed to
DTCs are not output A
DTCs are output B



Post-procedure1

c.

None



A

B

3.CHECK TELEPHONE TRANSCEIVER ASSEMBLY (GSW SIGNAL)
3.CHECK TELEPHONE TRANSCEIVER ASSEMBLY (GSW SIGNAL)

Pre-procedure1

a.
E422011C74
1.469,0.219 1.948,0.458 0.479,0.24 0.719,0.375 0.896,0.375 0.896,0.375 1.104,1.104 true 0.135,0.104 0.406,0.365 0.271,0.26 10 false *a 0.323,0.292 0.698,0.438 0.375,0.146 10 false GSW 1.604,0.271 2.042,0.521 0.438,0.25 10 false I55 0.208,4.031 0.646,4.292 0.438,0.26 10 false GND
*a Component with harness connected
(Telephone Transceiver Assembly)


Remove the telephone transceiver assembly but do not disconnect the connectors.

HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL



Procedure1

b.

Check the input waveform.

i.

Check the signal waveform according to the condition(s) in the table below. (Check the waveform from the back of the wire harness connector of the telephone transceiver assembly while the airbag sensor with ECU assembly connectors are connected.)

Reference Waveform:
Item Condition
Tester connection I55-13 (GSW) - Body ground
Tool setting 5.0 V/DIV., 20 ms/DIV.
Vehicle condition Ignition switch ON


OK:

The waveform is similar to that shown in the illustration.


Result:
Proceed to
OK
NG




Post-procedure1

c.

None



OK

4.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY

NG

5.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - AIRBAG SENSOR WITH ECU ASSEMBLY)
4.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
a.

Replace the telephone transceiver assembly with a new one.

HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL



Result:
Proceed to
NEXT



NEXT

5.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - AIRBAG SENSOR WITH ECU ASSEMBLY)

Pre-procedure1

a.

Disconnect the I55 telephone transceiver assembly connector.


b.

Disconnect the I24 airbag sensor with ECU assembly connector.


Procedure1


Post-procedure1

d.

None



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR