| *A | w/ Cool Box | *B | w/o Cool Box |
| *C | w/o Front Seat Side Airbag | - | - |
| *A | for LHD | *B | for RHD |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the airbag ECU assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/o Front Seat Side Airbag)
|
|
for 1GR-FE:
for V35A-FTS:
for F33A-FTV:
3.REMOVE FRONT SEAT ASSEMBLY LH
for Manual Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL
for Power Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL
4.REMOVE FRONT SEAT ASSEMBLY RH
Use the same procedure described for the LH side.
5.REMOVE COOLING BOX ASSEMBLY (w/ Cool Box)
58901A 6.REMOVE REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box)
67914B 8.REMOVE FRONT DOOR SCUFF PLATE LH
62112 9.REMOVE COWL SIDE TRIM BOARD LH
55607 10.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
67913B 11.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
62111C 12.REMOVE COWL SIDE TRIM BOARD RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
58510D 13.REMOVE FRONT FLOOR CARPET ASSEMBLY
88576C 14.REMOVE NO. 1 COOLER AIR DUCT
87212K 15.REMOVE REAR NO. 6 AIR DUCT
87212H 16.REMOVE REAR NO. 4 AIR DUCT
87212J 17.REMOVE REAR NO. 5 AIR DUCT
87212G 18.REMOVE REAR NO. 3 AIR DUCT
87212F 19.REMOVE REAR NO. 2 AIR DUCT
87212 20.REMOVE REAR NO. 1 AIR DUCT
89170A 21.REMOVE AIRBAG ECU ASSEMBLY
| *a | Turns off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
|
Push the Connector Lock |
|
Pull Out the Lock Lever |
Perform the following procedure to remove the airbag ECU assembly.
1. Pull out each connector with its connector lock pushed to disconnect the 3 connectors.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
2. Remove the 3 bolts and airbag ECU assembly.
If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the airbag ECU assembly with a new one.