Home › Drivetrain › AJA0F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM (for F33A-FTV) › from 2021.07
RM38G0E _52 Drivetrain _100435 AJA0F AUTOMATIC TRANSMISSION / TRANSAXLE _0488019 AUTOMATIC TRANSMISSION SYSTEM(for F33A-FTV) D

AJA0F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM(for F33A-FTV)  MONITOR DRIVE PATTERN  


MONITOR DRIVE PATTERN FOR ECT


CAUTION:

Perform this drive pattern on a level surface and strictly observe the posted speed limits and traffic laws while driving.


HINT:

Performing this drive pattern is one method to simulate TCM (ECT) malfunction detection conditions. Some DTCs may not be detected through ordinary, everyday driving. DTCs may not be detected through this drive pattern.


a.

Preparation for driving

i.

Warm up the engine sufficiently (engine coolant temperature of 60°C (140°F) or higher).


ii.

Drive the vehicle when the ambient temperature is -10°C (14°F) or higher.

Some malfunctions are not detected when the ambient temperature is below -10°C (14°F).



b.

Drive pattern

i.

Drive the vehicle through all the gears.

Stop → 1st → 2nd → 3rd → 4th → 5th → 6th → 7th → 8th → 9th → 10th.

HINT:

Lock-up will be engaged while driving in 2nd gear or higher.



ii.

Perform an engine braking test with the shift lever in M. While driving in the M10 range and 10th gear lock-up ON, move the shift lever to "-" and down-shift from 10th → 9th, 9th → 8th, 8th → 7th, 7th → 6th, 6th → 5th, 5th → 4th, 4th → 3rd, 3rd → 2nd and 2nd → 1st.

Check that engine braking is normal for every down-shift.


iii.

Repeat the above drive pattern 3 times or more.

NOTICE:
·

When using the GTS, the monitor status can be checked in the Data List.

Click hereDrivetrain>AJA0F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM (for F33A-FTV)>DATA LIST / ACTIVE TEST

·

In the event that the drive pattern must be interrupted (due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.

·

Perform this drive pattern on a level road as much as possible and strictly observe the posted speed limits and traffic laws while driving.

·

It is necessary to drive the vehicle for approximately 30 minutes to detect DTC P071000 (Transmission Fluid Temperature Sensor "A" Circuit Range/Performance).



C379512E01
2.344,1.646 2.719,0.365 2.719,0.365 2.958,0.365 false 4.823,2.396 5.094,1.135 5.094,1.135 5.333,1.135 false 1.677,2.917 2.552,4.26 2.552,4.26 2.74,4.26 false 3.229,3.375 3.604,3.792 3.604,3.792 3.917,3.792 false 0.323,0.844 2.313,1.042 1.99,0.198 10 false Vehicle Speed 0.031,1.583 1.188,2.354 1.156,0.771 10 false Approximately 100 km/h (62 mph) 0.104,2.333 1.26,3.104 1.156,0.771 10 false Approximately 80 km/h (50 mph) 1.094,3.281 3.083,3.479 1.99,0.198 10 false 0 0.333,3.625 3.698,3.823 3.365,0.198 10 false Warmed up sufficiently 2.844,4.188 5.344,4.583 2.5,0.396 10 false Normal acceleration through all the gears from 1st to 10th 4.01,3.719 6,3.917 1.99,0.198 10 false Stop (Idling) 5.396,1.063 7.104,1.385 1.708,0.323 10 false Lock-up ON Vehicle Speed 3.042,0.292 6.396,0.729 3.354,0.438 10 false Maintain a constant speed or gradual acceleration (with the throttle valve open) for 3 minutes or more.*

HINT:

*: Drive at a speed in the highest gear that will cause lock-up to engage. The vehicle can be driven at a speed lower than the speed shown in the above diagram under lock-up.