Home › Drivetrain › AJA0F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM (for F33A-FTV) › from 2021.07
RM38G0E _52 Drivetrain _100435 AJA0F AUTOMATIC TRANSMISSION / TRANSAXLE _0488019 AUTOMATIC TRANSMISSION SYSTEM(for F33A-FTV) C

AJA0F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM(for F33A-FTV)  P050031  Vehicle Speed Sensor "A" No Signal  


DESCRIPTION

The No. 2 skid control ECU (brake actuator assembly) converts the vehicle speed pulse signals output from the speed sensors installed to each wheel into vehicle speed signals and inputs these signals to the TCM.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P050031 Vehicle Speed Sensor "A" No Signal All conditions are met for 5 seconds or more (1-trip detection logic):
·

Transmission revolution sensor (SP2) value is 10 km/h (6.22 mph) or more.

·

Transmission revolution sensor (NT) value is 1500 rpm or more.

·

Shift lever is in D.

·

Vehicle speed signal is not input from the No. 2 skid control ECU.


·

CAN communication system

·

No. 2 skid control ECU (Brake actuator assembly)


Comes on DTC stored SAE: P0500

MONITOR DESCRIPTION

If there is no speed signal from the No. 2 skid control ECU even though the TCM determines that the vehicle is being driven, the TCM interprets this as a malfunction in the speed signal circuit. The TCM then illuminates the MIL and stores this DTC.

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.


1.

Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

2.

Turn the ignition switch off and wait for at least 30 seconds.

3.
4.

Enter the following menus: Powertrain / Transmission / Utility / All Readiness.

5.

Input the DTC: P050031.

6.

Check the DTC judgment result.

GTS Display Description
NORMAL
·

DTC judgment completed

·

System normal


ABNORMAL
·

DTC judgment completed

·

System abnormal


INCOMPLETE
·

DTC judgment not completed

·

Perform driving pattern after confirming DTC enabling conditions


N/A
·

Unable to perform DTC judgment

·

Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit



HINT:
·

If the judgment result shows NORMAL, the system is normal.

·

If the judgment result shows ABNORMAL, the system has a malfunction.

·

If the judgment result shows INCOMPLETE or N/A, perform the Confirmation Driving Pattern and check the DTC judgment result again.




PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

HINT:

Check the CAN communication system, and proceed to the next step if no malfunction is recognized.


Result:
Proceed to
NEXT



NEXT