The TCM and engine stop and start ECU send and receive signals via CAN communication.
If a communication error occurs between the TCM and engine stop and start ECU, the TCM stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| U110387 | Lost Communication with Stop and Start Control Module Missing Message | While the ignition switch is ON, there is no communication between the TCM and engine stop and start ECU for 1.16 seconds or more (1-trip detection logic). |
·
TCM
·
Engine stop and start ECU
·
CAN communication system |
Does not come on | DTC stored | SAE: U1103 |
After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / Transmission / Utility / All Readiness.
Input the DTC: U110387.
Check the DTC judgment result.
| GTS Display | Description |
|---|---|
| NORMAL |
·
DTC judgment completed
·
System normal |
| ABNORMAL |
·
DTC judgment completed
·
System abnormal |
| INCOMPLETE |
·
DTC judgment not completed
·
Perform driving pattern after confirming DTC enabling conditions |
| N/A |
·
Unable to perform DTC judgment
·
Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit |
If the judgment result shows NORMAL, the system is normal.
If the judgment result shows ABNORMAL, the system has a malfunction.
If the judgment result shows INCOMPLETE or N/A, perform the Confirmation Driving Pattern and check the DTC judgment result again.
Perform registration and/or initialization when parts related to the automatic transmission are replaced.
Clear the DTCs.
Write down the currently output DTCs before clearing them.
Start the engine and drive the vehicle at a low speed.
| Proceed to |
|---|
| NEXT |
NEXT
Read the DTCs using the GTS.
| Result | Proceed to |
|---|---|
| DTC U110387 is not output | A |
| DTC U110387 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B