Home › Power Source / Network › F33A-FTV (BATTERY / CHARGING) › CHARGING SYSTEM › from 2021.07
RM38G0E _57 Power Source / Network _106328 F33A-FTV BATTERY / CHARGING _0489033 CHARGING SYSTEM C

F33A-FTV BATTERY / CHARGING  CHARGING SYSTEM  P160200  Deterioration of Battery Low Capacity  


DESCRIPTION

The battery condition is calculated from the voltage when the engine is running (except when cranking) and then output to the ECM. A DTC is output when battery degradation is determined based on this signal.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Note
P160200 Deterioration of Battery Low Capacity While engine is running (except when cranking), battery capacity is abnormally low for 10 seconds or more.
(1 trip detection logic)
·

Battery

·

Wire harness or connector


Charge warning is not displayed SAE: P1602

WIRING DIAGRAM

A480733E03
0.854,2.708 1.594,2.99 0.74,0.281 10 false Battery 1.292,1.146 2.344,1.385 1.052,0.24 10 false SUB R/B-NO. 1 2.51,1.156 3.667,1.458 1.156,0.302 10 false EFI MAIN NO. 1 3.854,1.156 4.667,1.448 0.813,0.292 10 false EFI NO. 2 5.792,3.177 6.156,3.365 0.365,0.188 10 false ECM 5.292,0.833 5.698,1.01 0.406,0.177 10 false BATT 5.052,0.833 5.198,1.01 0.146,0.177 10 false 1 5.292,2.365 5.698,2.542 0.406,0.177 10 false E1 5.792,3.01 6.198,3.188 0.406,0.177 10 false B70 5,2.229 5.438,2.438 0.438,0.208 10 false 10

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK CHARGING SYSTEM

OK

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE OF ECM)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE OF ECM)
a.

Disconnect the ECM connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition

Click Location & Routing(B70)Location & Routing

Click Connector(B70)Engine Compartment>Engine Room Main Wire / Lamp Wire / No. 2 Engine Room Wire / No. 2 Lamp Wire / No. 3 Engine Room Wire / No. 6 Engine Room Wire / Washer Wiring Assembly>ECM

B70-1 (BATT) - Body ground Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR