Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › GRILLE SHUTTER SYSTEM › from 2021.07
RM38G0E _59 Vehicle Exterior _100846 EXTERIOR PANELS / TRIM _0469188 GRILLE SHUTTER SYSTEM J

EXTERIOR PANELS / TRIM  GRILLE SHUTTER SYSTEM  Grille Shutter is Half Opened/Closed  


DESCRIPTION

The grille shutter of the radiator shutter sub-assembly may only half open/close when dirty due to foreign matter, snow, mud, etc.

CAUTION / NOTICE / HINT

NOTICE:
·

Before performing troubleshooting, change the grille shutter control mode to maintenance mode.

for V35A-FTS:

Click hereEngine / Hybrid System>V35A-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION

for F33A-FTV (w/o DPF):

Click hereEngine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>INITIALIZATION

·

If the radiator shutter assembly has been replaced with a new one, perform initialization and change the grille shutter control mode.

for V35A-FTS:

Click hereEngine / Hybrid System>V35A-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION

for F33A-FTV (w/o DPF):

Click hereEngine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>INITIALIZATION



PROCEDURE

1.PERFORM UTILITY USING GTS (SWITCH GRILLE SHUTTER CONTROL MODE)
a.

According to the display on the GTS, change the grille shutter control mode from normal mode to maintenance mode.

Powertrain > Engine > Utility
Tester Display
Switch Grille Shutter Control Mode
50005 372 4672

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR FOREIGN OBJECT (FOREIGN MATTER AND ICE)
2.CHECK FOR FOREIGN OBJECT (FOREIGN MATTER AND ICE)
a.

Check the area around the shutters and the links of the grille shutter for foreign matter and ice.

OK:

The radiator shutter assembly is free of foreign matter and ice.



Result:
Proceed to
OK
NG



OK

3.INITIALIZE GRILLE SHUTTER SYSTEM

NG

6.REMOVE FOREIGN MATTER OR ICE (CLEAN GRILLE SHUTTER)
3.INITIALIZE GRILLE SHUTTER SYSTEM
a.

According to the display on the GTS, perform initialization (nominal torque).

Powertrain > Engine > Utility
Tester Display
Grille Shutter Initialization
50005 372 4673

Result:
Proceed to
NEXT



NEXT

4.PERFORM ACTIVE TEST USING GTS (CONTROL THE GRILLE SHUTTER)
4.PERFORM ACTIVE TEST USING GTS (CONTROL THE GRILLE SHUTTER)
a.

Use the GTS to perform Active Test to operate the grille shutter and remove any foreign matter.

HINT:

If foreign matter is trapped on the opening side, move the grille shutter in the closing direction. If foreign matter is trapped on the closing side, move the grille shutter in the opening direction.


Powertrain > Engine > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Control the Grille Shutter Operation of swing grille actuator assembly 0% (Fully open) to 100% (Fully closed) Perform this test when the following conditions are met:
·

Ignition switch ON

·

Battery voltage 10.5 to 16 V


Powertrain > Engine > Active Test
Tester Display
Control the Grille Shutter
50004 372 42033

Result:
Proceed to
NEXT



NEXT

5.PERFORM UTILITY USING GTS (GRILLE SHUTTER CONTROL MODE)
5.PERFORM UTILITY USING GTS (GRILLE SHUTTER CONTROL MODE)
a.

According to the display on the GTS, change the grille shutter control mode from maintenance mode to normal mode.

Powertrain > Engine > Utility
Tester Display
Switch Grille Shutter Control Mode
50005 372 5672

b.

Read the Data List according to the display on the GTS.

Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Grille Shutter Control Mode Grille shutter control mode Normal or Maintenance Normal: Normal mode
Maintenance: Maintenance mode
-
Powertrain > Engine > Data List
Tester Display
Grille Shutter Control Mode
50003 372 1304
OK:

Normal is displayed.



Result:
Proceed to
NEXT



NEXT

END

6.REMOVE FOREIGN MATTER OR ICE (CLEAN GRILLE SHUTTER)
a.

Remove any foreign matter and/or ice from the area around the shutters and the links of the grille shutter.


Result:
Proceed to
NEXT



NEXT

5.PERFORM UTILITY USING GTS (GRILLE SHUTTER CONTROL MODE)