| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT FENDER MOULDING SUB-ASSEMBLY LH | 75602A | ( ) |
- | - |
| 2 | FRONT FENDER MOULDING SUB-ASSEMBLY LH | 75602A | ( ) |
- | - |
| 3 | FRONT FENDER WHEEL ORNAMENT PAD | - | ( ) |
- | - |
| *A | for GR SPORT | *B | except GR SPORT |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
75602A 1.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH (for GR SPORT)
|
Screw |
|
Clip |
Put protective tape around the front fender moulding sub-assembly LH.
Using a 4 mm hexagon socket wrench, remove the 2 screws.
Remove the 5 clips.
Insert a screwdriver with its tip wrapped with protective tape into the gap and detach the claw.
Using moulding remover B, detach the clip in the order shown in the illustration and remove the front fender moulding sub-assembly LH as shown in the illustration.
Detach the clip one by one.
75602A 2.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH (except GR SPORT)
|
|
| Part | Temperature |
|---|---|
| Front Fender Moulding Sub-assembly LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front fender moulding sub-assembly LH excessively.
| *a | Double-sided Tape | - | - |
|
Screw |
|
Clip |
Put protective tape around the front fender moulding sub-assembly LH.
Using a 4 mm hexagon socket wrench, remove the 2 screws.
Remove the 5 clips.
Insert a screwdriver with its tip wrapped with protective tape into the gap and detach the claw.
Heat the adhesive of the front fender moulding sub-assembly LH using a heat light.
Using moulding remover B, detach the clip and double-sided tape in the order shown in the illustration and remove the front fender moulding sub-assembly LH as shown in the illustration.
Detach the clip one by one.
3.REMOVE FRONT FENDER WHEEL ORNAMENT PAD (except GR SPORT)
|
|
| Part | Temperature |
|---|---|
| Front Fender Wheel Ornament Pad | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front fender wheel ornament pad excessively.
Heat the adhesive of the front fender wheel ornament pad using a heat light.
Remove the front fender wheel ornament pad.