| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | CLEAN PROPELLER SHAFT GREASE | - | ( ) |
- | - |
| 2 | FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER KIT | 04371G | ( ) |
- | - |
| *A | for V35A-FTS and F33A-FTV | - | - |
| *1 | PROPELLER SHAFT | *2 | SPIDER BEARING |
| *3 | SPIDER | *4 | FLANGE YOKE |
| *5 | SLEEVE YOKE | - | - |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | CLEAN PROPELLER SHAFT GREASE | - | ( ) |
- | - |
| 2 | FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER KIT | 04371G | ( ) |
- | - |
| *A | for 1GR-FE | - | - |
| *1 | PROPELLER SHAFT | *2 | SPIDER BEARING |
| *3 | SPIDER | *4 | FLANGE YOKE |
| *5 | SLEEVE YOKE | - | - |
| ● | Non-reusable part | - | - |
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
1.CLEAN PROPELLER SHAFT GREASE
| *a | Matchmark | - | - |
Place matchmarks on the propeller shaft and sleeve yoke.
Disconnect the sleeve yoke from the propeller shaft.
Clean off any grease on the spline.
04371G 2.REMOVE FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER KIT
|
|
| *a | Matchmark | *b | Turn |
| *c | Hold | *d | Hammering Point |
Place matchmarks on the flange yoke and propeller shaft.
Using a brass bar and hammer, slightly tap in the spider bearing outer races.
Using 2 screwdrivers, remove the 4 snap rings from the grooves.
Using SST, remove the spider bearing from the front propeller shaft assembly.
Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.
Tap off the spider bearing with a hammer.
Do not tap the shaft.
Remove the spider bearing on the opposite side using the same procedure.
Remove the flange yoke from the front propeller shaft assembly.
Install the 2 removed spider bearing outer races to the spider.
Using SST, remove the spider bearing from the flange yoke.
Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.
Tap off the spider bearing with a hammer.
Remove the spider.