|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
77871A 1.INSTALL UREA PUMP
| *a | SST (Fuel Pump Retainer Tool) | *b | SST (Claw A) |
| *c | SST (Claw B) | *d | SST (Handle) |
Install SST (urea pump reatainer tool) to SST (clow A) and SST (clow B).
Install SST (handle) to SST (urea pump retainer tool).
| *a | Lock Plate | *b | Cutout |
| *c | Matchmarks | *d | Lock Plate Holes |
Install a new gasket to the urea pump.
Rotate the lock plate to temporarily install the urea pump.
Align the SST (clow B) with the cutout of the lock plate, and tighten the lock plate.
Do not use any tools other than SST, such as screwdriver, etc.
Make sure to rotate SST (handle) horizontally. If it is rotated at an angle, SST may come off.
Do not use an impact wrench or turn SST handle with excessive force, as parts may be damaged.
Check that the matchmarks of the urea tank are aligned with the positions of the lock plate holes.
77840A 2.CONNECT UREA TUBE WITH HEATER ASSEMBLY
|
|
Attach the clamp and connect the connector to the urea tank sub-assembly.
Wash the connection area of the urea tube with heater connector with water to remove all solidified urea solution (white solids).
Wipe off the connection area of the urea pump with water to remove all solidified urea solution (white solids).
Align the axis of the connector with the axis of the urea pump. Push the urea tube connector into the urea pump until the urea tube connector makes a "click" sound.
After connecting the urea pump and the urea tube connector, check that the urea pump and urea tube connector are securely connected by trying to pull them apart.
77885 3.CONNECT UREA TANK HARNESS
Connect the connector to the urea tube with heater assembly.
Connect the 2 connectors to the urea pump and push down on the lever to lock it.
When connecting a connector, make sure that dirt, water and other foreign matter is not stuck between the connector and urea pump.
Securely lock the lever.
77851A 4.INSTALL UREA TANK PROTECTOR
5.ADD UREA SOLUTION (AdBlue)
77830A 6.INSTALL UREA TANK CAP ASSEMBLY
51450C 7.INSTALL FRAME UNDER COVER ASSEMBLY LH
51420 8.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
51410 9.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY