| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | EGR GAS TEMPERATURE SENSOR | 89425B | ( ) |
- | - |
| 2 | NO. 1 ENGINE COVER SUB-ASSEMBLY | 12601B | - | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with union nut wrench |
89425G 1.INSTALL EGR GAS TEMPERATURE SENSOR
| *a | Torque Wrench Fulcrum Length | - | - |
Using a 14 mm union nut wrench, install the EGR gas temperature sensor.
If the EGR gas temperature sensor is dropped, replace the new one.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
When using a union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 26.3 N*m (268 kgf*cm, 19 ft.*lbf)
Attach the clamp.
Connect the connector to the EGR gas temperature sensor.
12601B 2.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY