Home › Engine / Hybrid System › F33A-FTV (FUEL) › COMMON RAIL › from 2021.07
RM38G0E _51 Engine / Hybrid System _106331 F33A-FTV FUEL _0493053 COMMON RAIL A

F33A-FTV FUEL  COMMON RAIL  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
A492344N02
1.01,1.385 1.26,0.969 1.26,0.969 1.427,0.969 false 6.385,0.25 6.823,0.25 false 6.344,0.719 6.771,0.719 false 5.729,3.823 6.177,3.823 false 5.833,5.375 6.417,5.375 false 3.667,2.208 3.917,1.708 3.917,1.708 4.083,1.708 false 4.635,3.885 4.885,3.135 4.885,3.135 5.052,3.135 false 5.365,1.51 5.667,1.948 5.667,1.948 5.833,1.948 false 3.135,0.656 3.594,0.344 3.594,0.344 3.854,0.344 false 4.5,3.75 4.167,3.563 4.167,3.563 3.99,3.563 false 5.677,5.198 5.906,4.583 5.906,4.583 6.073,4.583 true 0.781,0.615 1.063,0.76 0.281,0.146 10 false x 4 4.49,2.177 4.771,2.323 0.281,0.146 10 false x 3 5.615,3.354 5.896,3.5 0.281,0.146 10 false x 2 5.156,4.958 5.438,5.104 0.281,0.146 10 false x 2 5.969,0.094 6.406,0.365 0.438,0.271 18 false 1, 2 6.188,0.573 6.385,0.844 0.198,0.271 18 false 3 0.719,1.229 0.917,1.5 0.198,0.271 18 false 4 1.469,0.813 1.667,1.083 0.198,0.271 18 false 5 5.885,1.802 6.083,2.073 0.198,0.271 18 false 6 5.271,2.979 5.469,3.25 0.198,0.271 18 false 7 4.135,1.552 4.333,1.823 0.198,0.271 18 false 8 6.635,5.219 6.833,5.49 0.198,0.271 18 false 9 6.49,3.677 6.813,3.948 0.323,0.271 18 false 10 5.094,3.031 5.25,3.229 0.156,0.198 10 false ● 6.448,5.292 6.604,5.49 0.156,0.198 10 false ● 3.906,0.188 4.104,0.458 0.198,0.271 18 false 4 5.625,1.031 5.906,1.177 0.281,0.146 10 false x 3 5.604,5.229 5.885,5.375 0.281,0.146 10 false x 2 3.625,3.458 3.781,3.656 0.156,0.198 10 false ● 3.792,3.469 4.042,3.646 0.25,0.177 10 false *1 6.115,4.479 6.271,4.677 0.156,0.198 10 false ● 6.271,4.49 6.521,4.667 0.25,0.177 10 false *1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION FOR WORK - (Click here) - -
2 PRECAUTION - (Click here) - -
3 DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL - - - -
4 TURBOCHARGER ASSEMBLY - - - -
5 INJECTION PUMP INSULATOR 22815A - - -
6 VENTILATION PIPE 12229 - - -
7 NO. 5 INJECTION PIPE SUB-ASSEMBLY 23705 - - -
8 INTERCOOLER SUPPORT BRACKET 17945 - - -
9 NO. 6 INJECTION PIPE SUB-ASSEMBLY 23706 - - -
10 COMMON RAIL ASSEMBLY (for Bank 2) 23820A (Click here) - -

*1 NO. 1 INJECTION PIPE CLAMP - -
● Non-reusable part - -

A534065N01
1.542,2.458 2.052,2.458 false 1.313,0.781 1.521,0.781 1.521,0.781 1.729,1.344 false 2.927,2.76 3.375,2.615 3.375,2.615 3.542,2.615 false 5.313,2.385 5.698,2.094 5.698,2.094 5.906,2.094 false 5.979,3.698 6.25,3.427 6.25,3.427 6.417,3.427 false 5.5,3.427 5.792,3.094 5.792,3.094 5.958,3.094 false 3.99,0.75 4.573,0.75 false 5.625,3.948 5.771,4.26 5.771,4.26 5.938,4.26 false 0.896,0.406 1.479,0.406 false 0.594,1.719 0.979,1.719 false 0.938,1.115 1.354,1.115 false 5.396,2.917 5.917,2.656 5.917,2.656 6.146,2.656 false 2.313,2.167 2.563,2.313 0.25,0.146 10 true x 2 6.396,3.708 6.646,3.854 0.25,0.146 10 false x 4 6.448,3.281 6.76,3.563 0.313,0.281 18 false 11 6.177,2.958 6.49,3.24 0.313,0.281 18 false 12 6.135,1.948 6.448,2.229 0.313,0.281 18 false 13 4.604,0.615 4.917,0.896 0.313,0.281 18 false 14 3.563,2.458 3.875,2.74 0.313,0.281 18 false 15 1.219,2.323 1.531,2.604 0.313,0.281 18 false 18 1.042,0.625 1.354,0.906 0.313,0.281 18 false 17 0.281,1.573 0.635,1.833 0.354,0.26 18 false 16 0.615,0.26 0.927,0.542 0.313,0.281 18 false 19 6,3.01 6.156,3.208 0.156,0.198 10 false ● 0.865,0.667 1.021,0.865 0.156,0.198 10 false ● 5.969,2.01 6.125,2.208 0.156,0.198 10 false ● 6.156,4.125 6.469,4.406 0.313,0.281 18 false 12 5.979,4.188 6.135,4.385 0.156,0.198 10 false ● 0.75,1.031 0.969,1.198 0.219,0.167 10 false *1 6.365,2.573 6.615,2.729 0.25,0.156 10 false *2 6.198,2.552 6.354,2.75 0.156,0.198 10 false ●

Procedure Part Name Code
Z101186

Z101188

Z101187

11 NO. 1 WATER OUTLET PIPE 16332 - - -
12 WATER OUTLET GASKET 16341 - - -
13 NO. 4 INJECTION PIPE SUB-ASSEMBLY 23704 - - -
14 NO. 2 VACUUM SWITCHING VALVE ASSEMBLY 25860D - - -
15 FUEL HOSE 23802F - - -
16 NO. 5 FUEL PIPE SUB-ASSEMBLY 23805B (Click here) - -
17 FUEL PIPE GASKET 23804H - - -
18 COMMON RAIL ASSEMBLY (for Bank 1) 23810A (Click here) - -
19 NO. 3 CONNECTING WIRE 27148F - - -

*1 UNION BOLT *2 NO. 1 INJECTION PIPE CLAMP
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the common rail assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function when Necessary Procedures are not Performed Link
Battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -



CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.


·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



PROCEDURE

Hide 1. PRECAUTION FOR WORK

Z101186

NOTICE:
·

If foreign matter enters the fuel path, it will damage the fuel injection components. Make sure foreign matter does not enter the fuel path.

·

Clean the installation area of the injection pipe to remove foreign matter.

·

The common rail assembly is a precision instrument. Do not use the common rail assembly if it is struck or dropped.

·

Hold the common rail assembly itself during removal and installation. Do not hold the pressure discharge valve.




Hide 2. PRECAUTION

Z101186

NOTICE:

After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click here(Click here)



Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 22815A 5.REMOVE INJECTION PUMP INSULATOR

a.
A492346


Hide 12229 6.REMOVE VENTILATION PIPE

a.
A492365


Hide 23705 7.REMOVE NO. 5 INJECTION PIPE SUB-ASSEMBLY

a.
A492347


Hide 17945 8.REMOVE INTERCOOLER SUPPORT BRACKET

a.
A492349


Hide 23706 9.REMOVE NO. 6 INJECTION PIPE SUB-ASSEMBLY

a.
A492350


Hide 23820A 10.REMOVE COMMON RAIL ASSEMBLY (for Bank 2)

Z101186

NOTICE:

Do not remove the pressure discharge valve.



a.
A492354


Hide 16332 11.REMOVE NO. 1 WATER OUTLET PIPE

a.
A492355


Hide 16341 12.REMOVE WATER OUTLET GASKET

a.
A492356


Hide 23704 13.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY

a.
A492357


Hide 25860D 14.REMOVE NO. 2 VACUUM SWITCHING VALVE ASSEMBLY

Hide 23802F 15.DISCONNECT FUEL HOSE

a.
A492360


Hide 23805B 16.REMOVE NO. 5 FUEL PIPE SUB-ASSEMBLY

Z101186

NOTICE:

Do not use air tools or electric tools when loosening the union bolt.



a.
A492361


Hide 23804H 17.REMOVE FUEL PIPE GASKET

a.
A492362


Hide 23810A 18.REMOVE COMMON RAIL ASSEMBLY (for Bank 1)

Z101186

NOTICE:

Do not remove the pressure discharge valve.



a.
A492363


Hide 27148F 19.REMOVE NO. 3 CONNECTING WIRE

a.
A492364