| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Note |
|---|---|---|---|---|---|
| P004646 | Turbocharger/Supercharger Boost Control "A" Circuit Range/Performance Calibration / Parameter Memory Failure | The VN turbo model code, VN turbo fully closed calibration value bank 1 or VN turbo fully closed calibration value bank 2 is not registered. (1 trip detection logic) |
·
VN Turbo Offset Voltage Value
·
ECM |
Comes on | SAE Code: P0046 |
| DTC No. | Data List |
|---|---|
| P004646 |
·
VN Close Learn Value Bank 1
·
VN Turbo 2 Close Learn Value |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P004646 | Check that VN Turbo Offset Voltage Value has changed after performing VN Turbo Offset Voltage Value Compensation. |
After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>REGISTRATION) and initialization (Click here Engine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>INITIALIZATION).
When replacing the turbocharger sub-assembly, calibrate the VN turbo offset voltage value and initialize the learning values after replacement.
Click hereEngine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>REGISTRATION
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Check VN Turbo Offset Voltage Value Compensation by performing Learning Values Confirmation.
Perform this procedure to check that it has changed after registering VN turbo offset voltage value compensation code.
| Tester Display |
|---|
| Learning Values Confirmation |
Register the VN turbo offset voltage value compensation code.
Click hereEngine / Hybrid System>F33A-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>REGISTRATION
| Tester Display |
|---|
| VN Turbo Offset Voltage Value Compensation |
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Turn the ignition switch off and leave the vehicle for 30 seconds or more.
Check that VN Turbo Offset Voltage Value has changed after performing VN Turbo Offset Voltage Value Compensation.
| Tester Display |
|---|
| Learning Values Confirmation |
Read the DTCs.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT