Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM (w/ Headlight ECU) › from 2022.11
RM38G0E _59 Vehicle Exterior _100649 LIGHTING (EXT) _0468731 LIGHTING SYSTEM(w/ Headlight ECU) C

LIGHTING (EXT)  LIGHTING SYSTEM(w/ Headlight ECU)  B241A1C  Rear Height Sensor Circuit Voltage Out of Range  


DESCRIPTION

The headlight ECU sub-assembly LH determines the vehicle height and performs automatic headlight beam level control based on signals from the rear height control sensor sub-assembly LH via direct line.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B241A1C Rear Height Sensor Circuit Voltage Out of Range
Detection condition:

The ignition switch is ON.


Malfunction status:

Abnormal vehicle height continuously detected


Malfunction duration:

10 seconds or more


for LHD
·

Rear height control sensor sub-assembly LH

·

Harness or connector

·

Headlight ECU sub-assembly LH


for RHD
·

Rear height control sensor sub-assembly LH

·

Harness or connector

·

Headlight ECU sub-assembly LH

·

Headlight cord LH


Headlight Control A

WIRING DIAGRAM

for LHD


E370854E88
4.208,2.344 6.708,2.708 2.5,0.365 10 false Headlight ECU Sub-assembly LH 4.208,2.177 4.594,2.427 0.385,0.25 10 false B4 2.865,0.5 3.156,0.75 0.292,0.25 10 false 1 2.844,0.99 3.135,1.24 0.292,0.25 10 false 2 2.844,1.5 3.135,1.75 0.292,0.25 10 false 3 4.958,0.302 5.25,0.552 0.292,0.25 10 false 5 V 2.406,0.573 2.74,0.823 0.333,0.25 10 false SHB 2.344,1.094 2.844,1.385 0.5,0.292 10 false SHRR 2.406,1.615 2.802,1.865 0.396,0.25 10 false SHG 0.594,2.135 0.885,2.385 0.292,0.25 10 false V1 0.594,2.313 3.458,2.677 2.865,0.365 10 false Rear Height Control Sensor Sub-assembly LH 4.094,1.5 4.385,1.75 0.292,0.25 10 false 15 4.344,1.521 4.729,1.771 0.385,0.25 10 false SGR 4.344,0.99 4.771,1.26 0.427,0.271 10 false SHRL 4.104,1 4.396,1.25 0.292,0.25 10 false 17 4.104,0.5 4.396,0.75 0.292,0.25 10 false 16 4.354,0.5 4.719,0.74 0.365,0.24 10 false SBR


for RHD


E503139E01
4.823,2.302 6.938,2.677 2.115,0.375 10 false Headlight ECU Sub-assembly LH 4.813,2.135 5.25,2.385 0.438,0.25 10 false B88 2.458,0.5 2.75,0.75 0.292,0.25 10 false 1 2.469,0.99 2.76,1.24 0.292,0.25 10 false 2 2.469,1.5 2.76,1.75 0.292,0.25 10 false 3 5.417,0.302 5.708,0.552 0.292,0.25 10 false 5 V 2.021,0.583 2.354,0.833 0.333,0.25 10 false SHB 1.917,1.094 2.417,1.385 0.5,0.292 10 false SHRR 1.99,1.615 2.385,1.865 0.396,0.25 10 false SHG 0.75,2.01 1.042,2.26 0.292,0.25 10 false V1 0.74,2.167 2.438,2.625 1.698,0.458 10 false Rear Height Control Sensor Sub-assembly LH 4.5,1.5 4.792,1.75 0.292,0.25 10 false 15 4.781,1.521 5.167,1.771 0.385,0.25 10 false SGR 4.792,0.99 5.219,1.26 0.427,0.271 10 false SHRL 4.51,1 4.802,1.25 0.292,0.25 10 false 17 4.5,0.49 4.792,0.74 0.292,0.25 10 false 16 4.781,0.5 5.146,0.74 0.365,0.24 10 false SBR 3.563,0.479 3.854,0.729 0.292,0.25 10 false 5 3.573,1.01 3.865,1.26 0.292,0.25 10 false 6 3.573,1.51 3.865,1.76 0.292,0.25 10 false 4 3.5,2.208 5.615,2.583 2.115,0.375 10 false Headlight Cord LH 3.5,2.031 5.615,2.406 2.115,0.375 10 false BB6


CAUTION / NOTICE / HINT

NOTICE:
·

If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Headlight ECU)>REGISTRATION

·

If any of the following are performed, it is necessary to initialize the headlight ECU sub-assembly LH.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Headlight ECU)>REGISTRATION

-

Replacement of the rear height control sensor sub-assembly LH

-

Removal/installation of the rear height control sensor sub-assembly LH

-

Work that changes the vehicle height such as replacement of suspension components


·

When replacing the headlight ECU sub-assembly LH, always replace it with a new one. If a headlight ECU sub-assembly LH which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Headlight Control > Clear DTCs
50002 462

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

Pre-procedure1

a.

Turn ignition switch to ON.


b.

Wait 10 seconds or more.


Post-procedure1

c.

Check for DTCs.

Body Electrical > Headlight Control > Trouble Codes
50001 462
Result:
Result Proceed to
B241A1C is not output A
B241A1C is output B



Procedure1

d.

None



A

B

3.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
3.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

OK

4.CHECK VEHICLE TYPE

NG

REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

4.CHECK VEHICLE TYPE
Result:
Result Proceed to
for LHD A
for RHD B



A

5.CHECK HARNESS AND CONNECTOR (REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH - HEADLIGHT ECU SUB-ASSEMBLY LH)

B

6.INSPECT HEADLIGHT CORD LH
5.CHECK HARNESS AND CONNECTOR (REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH - HEADLIGHT ECU SUB-ASSEMBLY LH)

Pre-procedure1

a.

Disconnect the B4 headlight ECU sub-assembly LH connector.


Procedure1

b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(V1,B4)Location & Routing

Click Connector(V1)Body>Differential Wire / Frame Wire>Height Control Sensor Sub-Assembly Rear RH

Click Connector(B4)Engine Compartment>Engine Room Main Wire / Lamp Wire / No. 2 Engine Room Wire / No. 2 Lamp Wire / No. 3 Engine Room Wire / No. 6 Engine Room Wire / Washer Wiring Assembly>Headlight ECU Sub-Assembly LH

V1-1 (SHB) - B4-16 (SBR) Always Below 1 Ω
V1-2 (SHRR) - B4-17 (SHRL) Always Below 1 Ω
V1-3 (SHG) - B4-15 (SGR) Always Below 1 Ω
V1-1 (SHB) or B4-16 (SBR) - Body ground Always 10 kΩ or higher
V1-2 (SHRR) or B4-17 (SHRL) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

c.

None



OK

REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.INSPECT HEADLIGHT CORD LH

Pre-procedure1

a.

Remove the headlight cord LH.

HINT:

Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>DISASSEMBLY



Procedure1

b.
E483588C22
1.563,0.365 1.969,0.615 0.406,0.25 1.479,2.323 1.885,2.573 0.406,0.25 2.24,3.958 1.927,3.5 true 2.292,2.01 2.083,1.552 true 1.656,0.406 2.063,0.75 0.406,0.344 10 false B88 1.563,2.375 2.177,2.906 0.615,0.531 10 false BB6 0.344,0.188 0.646,0.469 0.302,0.281 10 false *a 2.229,2.052 2.844,2.583 0.615,0.531 10 false LINL 2.323,3.896 2.938,4.427 0.615,0.531 10 false LINL
*a Component without harness connected
(Headlight Cord LH)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(B88,BB6)Location & Routing

Click Connector(B88)Engine Compartment>Engine Room Main Wire / Lamp Wire / No. 2 Engine Room Wire / No. 2 Lamp Wire / No. 3 Engine Room Wire / No. 6 Engine Room Wire / Washer Wiring Assembly>Headlight ECU Sub-Assembly LH

Click Connector(BB6)Engine Compartment>Engine Room Main Wire / Lamp Wire / No. 2 Engine Room Wire / No. 2 Lamp Wire / No. 3 Engine Room Wire / No. 6 Engine Room Wire / Washer Wiring Assembly>Engine Room Main Wire and No. 2 Lamp Wire

B88-16 (SBR) - BB6-5 (SBR) Always Below 1 Ω
B88-17 (SHRL) - BB6-6 (SHRL) Always Below 1 Ω
B88-15 (SGR) - BB6-4 (SGR) Always Below 1 Ω
B88-16 (SBR) or BB6-5 (SBR) - Other terminals Always 10 kΩ or higher
B88-17 (SHRL) or BB6-6 (SHRL) - Other terminals Always 10 kΩ or higher
B88-15 (SGR) or BB6-4 (SGR) - Other terminals Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

c.

None



OK

7.CHECK HARNESS AND CONNECTOR (REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH - HEADLIGHT ECU SUB-ASSEMBLY LH)

NG

7.CHECK HARNESS AND CONNECTOR (REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH - HEADLIGHT ECU SUB-ASSEMBLY LH)

Pre-procedure1

a.

Connect the BB6 headlight cord LH connector.


Procedure1

b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(V1,B88)Location & Routing

Click Connector(V1)Body>Differential Wire / Frame Wire>Height Control Sensor Sub-Assembly Rear RH

Click Connector(B88)Engine Compartment>Engine Room Main Wire / Lamp Wire / No. 2 Engine Room Wire / No. 2 Lamp Wire / No. 3 Engine Room Wire / No. 6 Engine Room Wire / Washer Wiring Assembly>Headlight ECU Sub-Assembly LH

V1-1 (SHB) - B88-16 (SBR) Always Below 1 Ω
V1-2 (SHRR) - B88-17 (SHRL) Always Below 1 Ω
V1-3 (SHG) - B88-15 (SGR) Always Below 1 Ω
V1-1 (SHB) or B88-16 (SBR) - Body ground Always 10 kΩ or higher
V1-2 (SHRR) or B88-17 (SHRL) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

c.

None



OK

REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR