| *1 | RETURN SPRING | *2 | PLUNGER |
| *3 | NO. 2 REPAIR SERVICE STARTER KIT | - | - |
1.REMOVE HARNESS
28226B 2.REMOVE REPAIR SERVICE STARTER KIT
| *1 | Pinion Drive Lever | *2 | Plunger |
| *3 | Return Spring | - | - |
| *a | Hook | - | - |
Remove the nut and disconnect the lead wire.
While holding the repair service starter kit to the No. 2 repair service starter kit, remove the 2 nuts.
While lifting the rear of the repair service starter kit, remove the hook from the pinion drive lever, then remove the repair service starter kit.
28120 3.REMOVE STARTER YOKE ASSEMBLY
Using a T25 "TORX" socket wrench, remove the 2 through bolts, and pull out the starter yoke assembly together with the starter commutator end frame assembly.
4.REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY
| *1 | Starter Yoke Assembly | *2 | Starter Commutator End Frame Assembly |
| *a | Lead Wire | - | - |
Remove the 2 screws.
While holding down the lead wire, remove the starter commutator end frame assembly from the starter yoke assembly.
28140 5.REMOVE STARTER BRUSH HOLDER ASSEMBLY
Remove the starter brush holder assembly from the starter armature assembly.
When removing the starter brush holder assembly, be careful not to damage the brush and commutator.
28160 6.REMOVE STARTER ARMATURE ASSEMBLY