17705 1.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE
| *A | for RHD |
| *B | for LHD |
for RHD:
Detach the accelerator control cable assembly from the air cleaner hose claw.
Remove the butterfly nut and detach the 3 clamps.
Loosen the hose clamp and disconnect the air cleaner hose.
Remove the air cleaner cap sub-assembly with hose.
25620 2.REMOVE EGR VALVE ASSEMBLY (w/ EGR System)
78180P 3.DISCONNECT ACCELERATOR CONTROL CABLE ASSEMBLY
for LHD:
Remove the bolt and accelerator control cable bracket from the cylinder head sub-assembly.
Remove the bolt and accelerator control cable bracket from the intake manifold.
w/ EGR System:
Detach the wire harness clamp from accelerator control cable assembly.
Loosen the nut and disconnect the accelerator control cable assembly.
17113 4.REMOVE INTAKE PIPE
w/ EGR System:
Disconnect the 2 connectors and 2 vacuum hoses.
Detach the vacuum hose clamp.
Disconnect the 2 vacuum hoses.
w/o EGR System:
Remove the 2 bolts and intake pipe stay from the intake pipe and cylinder head sub-assembly.
Remove the 3 bolts and disconnect the ventilation hose.
| *A | w/ EGR System | *B | w/o EGR System |
Remove the intake pipe and gasket from the intake manifold.
Remove the bolt and accelerator control cable bracket sub-assembly from the intake pipe.
44360 5.DISCONNECT VANE PUMP OIL RESERVOIR ASSEMBLY
Remove the 3 bolts and disconnect the vane pump oil reservoir assembly.
15301 6.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Detach the clamp from the engine oil level dipstick guide.
Remove the engine oil level dipstick.
Remove the bolt and engine oil level dipstick guide from the cylinder block sub-assembly.
Remove the O-ring from the engine oil level dipstick guide.
7.REMOVE INJECTION PIPE SUB-ASSEMBLY
78104 8.REMOVE NO. 2 ACCELERATOR CONNECTING ROD SUB-ASSEMBLY
Detach the 2 clamps and remove the No. 2 accelerator connecting rod sub-assembly from the injection pump assembly and No. 1 accelerator connecting rod sub-assembly.
78103 9.REMOVE NO. 1 ACCELERATOR CONNECTING ROD SUB-ASSEMBLY
w/ EGR System:
Disconnect the connector and detach the wire harness clamp from No. 1 accelerator connecting rod sub-assembly.
Remove the 2 bolts, nut and the No. 1 accelerator connecting rod sub-assembly from the intake manifold.
25860A 10.REMOVE NO. 1 VACUUM SWITCHING VALVE
Disconnect the 2 vacuum hoses from the No. 1 vacuum switching valve and connector.
Remove the bolt and No. 1 vacuum switching valve from the intake manifold.
11.DISCONNECT HEATER HOSE BRACKET
Remove the bolt and disconnect the heater hose bracket.
Remove the bolt and disconnect the heater hose valve bracket.
17111 12.REMOVE INTAKE MANIFOLD
w/ EGR System:
Remove the 2 bolts and 2 wire harness clamp brackets from the intake manifold.
Remove the 12 nuts and 12 seal washers from the intake manifold.
Remove the intake manifold, intake manifold gasket and 5 No. 2 intake manifold gaskets from the cylinder head sub-assembly.