11322A 1.REMOVE NO. 1 TIMING BELT COVER
Remove the 6 bolts, 6 seal washers, No. 1 timing belt cover and gasket.
2.SET NO. 1 CYLINDER TO BDC/COMPRESSION
| *1 | Camshaft Timing Pulley |
| *2 | No. 2 Camshaft Timing Pulley Flange |
| *a | Timing Marks |
|
Turn |
Turn the crankshaft pulley clockwise, align the timing marks of the camshaft timing pulley and No. 2 camshaft timing pulley flange with the BDC marks.
If the timing belt is disengaged, having the crankshaft pulley at the wrong angle can cause the piston head and valve head to come into contact with each other when you remove the camshaft timing pulley, thus resulting damage.
So always set the crankshaft pulley at the correct angle.
13568 3.REMOVE TIMING BELT
| *a | String |
When re-using timing belt:
Draw a direction arrow on the timing belt (in the direction of engine revolution), and place matchmarks on the camshaft timing pulley, No. 2 camshaft timing pulley flange and timing belt.
When replacing timing belt tensioner only:
To avoid meshing of the timing belt, secure one of them with string.
Alternately loosen the 2 bolts, and remove them and No. 1 chain tensioner assembly.
Remove the timing belt.
13505 4.REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
| *a | 8 mm Hexagon Wrench |
Using an 8 mm hexagon wrench, remove the pivot bolt, No. 1 timing belt idler sub-assembly and plate washer.
13528 5.REMOVE CAMSHAFT DRIVE GEAR
| *a | Matchmarks |
Place matchmarks on the No. 1 camshaft timing pulley flange and camshaft drive gear.
Remove the 4 bolts, No. 2 camshaft timing pulley flange, camshaft drive gear and No. 1 camshaft timing pulley flange.
17113 6.REMOVE INTAKE PIPE
11201 7.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
Remove the 14 bolts, 2 nuts, cylinder head cover sub-assembly and gasket.
13523P 8.REMOVE CAMSHAFT TIMING PULLEY
| *a | Hold |
|
Turn |
Slightly turn the camshaft timing pulley counterclockwise and hold the hexagon wrench head portion of the camshaft with a wrench, and remove the pulley bolt and camshaft timing pulley.
Using SST, remove the camshaft timing pulley.
Remove the pulley set key.