Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › CYLINDER HEAD
RM25T0E _51 Engine / Hybrid System _029355 1HZ ENGINE MECHANICAL _0133480 CYLINDER HEAD A

1HZ ENGINE MECHANICAL  CYLINDER HEAD  REPLACEMENT  


PROCEDURE

Hide 11122 1.REPLACE VALVE GUIDE BUSH

a.

Gradually heat the cylinder head sub-assembly to approximately 80 to 100°C (176 to 212°F).


b.
A326292N01
1.521,0.76 0.948,0.583 0.948,0.583 0.74,0.583 true 1.521,1.219 0.948,0.594 true 0.427,0.521 0.75,0.729 0.323,0.208 10 false SST

Using SST and a hammer, tap out the valve guide bush.

SST
09201-10000  09950-70010  (09201-01080, 09951-07100)


c.
A326293

Using a caliper gauge, measure the bush bore diameter of the cylinder head sub-assembly.


d.

Select a new valve guide bush.

New Valve Guide Bush:
Item Specified Conditions
Bush Bore Diameter 13.004 to 13.025 mm (0.512 to 0.513 in.) 13.054 to 13.075 mm (0.514 to 0.515 in.)
Bush to be Used STD O/S 0.05


If the bush bore diameter of the cylinder head sub-assembly is more than 13.025 mm (0.513 in.), machine the bush bore to a dimension of 13.054 to 13.075 mm (0.514 to 0.515 in.).

If the bush bore diameter of the cylinder head sub-assembly is more than 13.075 mm (0.515 in.), replace the cylinder head sub-assembly.


e.

Gradually heat the cylinder head sub-assembly to approximately 80 to 100°C (176 to 212°F).


f.
A326294C01
0.573,0.604 0.813,0.604 0.813,0.604 1.385,0.802 true 1.417,1.313 0.844,0.625 true 2.844,1.333 3.052,1.51 0.208,0.177 10 false *a 0.271,0.531 0.594,0.729 0.323,0.198 10 false SST
*a Protrusion Height


Using SST and a hammer, tap in a new valve guide bush to the specified protrusion height.

Standard protrusion height:

11.8 to 12.2 mm (0.465 to 0.480 in.)


SST
09201-10000  09950-70010  (09201-01080, 09951-07100)


g.
A326295C01
1.74,0.292 1.927,0.292 1.927,0.292 2.406,0.75 false 1.563,0.198 1.74,0.396 0.177,0.198 10 false *a
*a Reamer


Using a sharp 8.0 mm reamer, ream the valve guide bush to obtain the specified clearance.

Click hereEngine / Hybrid System>1HZ (ENGINE MECHANICAL)>CYLINDER HEAD>INSPECTION