Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL
RM25T0E _51 Engine / Hybrid System _029355 1HZ ENGINE MECHANICAL _0133482 REAR CRANKSHAFT OIL SEAL A

1HZ ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 31250 1.REMOVE CLUTCH DISC ASSEMBLY

Hide 13405 2.REMOVE FLYWHEEL SUB-ASSEMBLY

a.
A329238N01
0.708,1.417 0.906,1.417 0.906,1.417 1.26,1.302 true 0.927,1.406 1.208,0.917 true 0.396,1.344 0.75,1.594 0.354,0.25 10 false SST

Using SST, hold the crankshaft.

SST
09213-58014  09330-00021  


b.
A326278

Remove the 8 bolts and flywheel sub-assembly.


Hide 11355 3.REMOVE REAR END PLATE

a.
A321600

Remove the bolt and rear end plate.


Hide 11381A 4.REMOVE REAR CRANKSHAFT OIL SEAL

a.

Using a knife, cut off the lip of the rear crankshaft oil seal.


b.
A326262C01
0.75,1.281 0.99,0.635 0.99,0.635 1.146,0.635 true 2.083,1.01 2.74,0.292 2.74,0.292 2.948,0.292 true 1.188,0.552 1.5,0.708 0.313,0.156 10 false *a 2.99,0.219 3.219,0.427 0.229,0.208 10 false *b
*a Cut Position
*b Protective Tape


Using a screwdriver, pry out the rear crankshaft oil seal.

NOTICE:

After the removal, check that the crankshaft is not damaged. If damaged, repair it with a sandpaper (#400).


HINT:

Tape the screwdriver before use.