Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL
RM25T0E _51 Engine / Hybrid System _029355 1HZ ENGINE MECHANICAL _0133482 REAR CRANKSHAFT OIL SEAL A

1HZ ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11381A 1.INSTALL REAR CRANKSHAFT OIL SEAL

a.

Apply MP grease to the lip of a new rear crankshaft oil seal.

NOTICE:

Keep the lip free from foreign matter.



b.
A326263N01
0.802,1.823 1.021,1.823 1.021,1.823 1.406,1.323 true 0.5,1.75 0.844,1.948 0.344,0.198 10 false SST

Using SST, tap in the rear crankshaft oil seal until its surface is flush with the rear engine oil seal retainer edge.

SST
09223-15030  

NOTICE:

Wipe off any extra grease on the crankshaft.



Hide 11355 2.INSTALL REAR END PLATE

a.

Install the rear end plate with the bolt.

Torque:
18.1 N*m (185 kgf*cm, 13 ft.*lbf)


Hide 13405 3.INSTALL FLYWHEEL SUB-ASSEMBLY

a.
A329238N01
0.708,1.417 0.906,1.417 0.906,1.417 1.26,1.302 true 0.927,1.406 1.208,0.917 true 0.396,1.344 0.75,1.594 0.354,0.25 10 false SST

Using SST, hold the crankshaft.

SST
09213-58014  09330-00021  


b.

Install the flywheel sub-assembly to the crankshaft.


c.
A326278N01
1.656,0.521 1.802,0.688 0.146,0.167 10 true 1 2.042,1.667 2.146,1.833 0.104,0.167 10 true 2 2.427,0.927 2.542,1.104 0.115,0.177 10 true 3 1.302,1.302 1.406,1.49 0.104,0.188 10 true 4 2.115,0.531 2.24,0.708 0.125,0.177 10 true 5 1.615,1.667 1.729,1.854 0.115,0.188 10 true 6 2.385,1.292 2.49,1.469 0.104,0.177 10 true 7 1.313,0.906 1.417,1.094 0.104,0.188 10 true 8

Uniformly install and tighten the 8 bolts in several steps in the sequence shown in the illustration.

Torque:
127.4 N*m (1299 kgf*cm, 94 ft.*lbf)


Hide 31250 4.INSTALL CLUTCH DISC ASSEMBLY