Home › Engine / Hybrid System › 1GR-FE (STARTING) › STARTER › 2014.08–2022.09
RM25T0E _51 Engine / Hybrid System _029357 1GR-FE STARTING _0133495 STARTER A

1GR-FE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, watching time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17105 3.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

Hide 28100 4.REMOVE STARTER ASSEMBLY

a.
A219007

Remove the bolt and disconnect the ground wire from the cylinder block.


b.

Disconnect the terminal cap.


c.

Remove the nut and disconnect the starter wire.


d.

Disconnect the starter connector.


e.
A218209

Remove the 3 bolts and starter cover from the starter assembly.


f.
A218197

Remove the 2 bolts and starter assembly from the cylinder block.


Hide 11363A 5.REMOVE FLYWHEEL HOUSING SIDE COVER

a.
A222907

Remove the flywheel housing side cover from the cylinder block.