Home › Engine / Hybrid System › 1GR-FE (INTAKE / EXHAUST) › EXHAUST MANIFOLD
RM25T0E _51 Engine / Hybrid System _029771 1GR-FE INTAKE / EXHAUST _0135415 EXHAUST MANIFOLD A

1GR-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves when removing the exhaust pipe.

·

The exhaust pipe is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe has cooled down before removing it.



PROCEDURE

Hide 17410 1.REMOVE FRONT EXHAUST PIPE SUB-ASSEMBLY

Hide 53737B 2.REMOVE FRONT FENDER APRON SEAL LH

a.
A273256

Using a clip remover, detach the 11 clips and remove the front fender apron seal LH.


Hide 53736 3.REMOVE FRONT FENDER APRON SEAL RH

a.
A273257

Using a clip remover, detach the 11 clips and remove the front fender apron seal RH.


Hide 17119 4.REMOVE NO. 2 MANIFOLD STAY

a.
A218331

Remove the 3 bolts and No. 2 manifold stay.


Hide 17105 5.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

a.

Disconnect the air fuel ratio sensor (for Bank 2 Sensor 1) and heated oxygen sensor (for Bank 2 Sensor 2) connectors.


b.
A167916

Remove the 6 nuts, exhaust manifold sub-assembly LH and gasket.


Hide 89467C 6.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

Hide 89465A 7.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

Hide 17118 8.REMOVE NO. 1 MANIFOLD STAY

a.
A218332

Remove the 3 bolts and No. 1 manifold stay.


Hide 17104 9.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

a.

Disconnect the air fuel ratio sensor (for Bank 1 Sensor 1) and heated oxygen sensor (for Bank 1 Sensor 2) connectors.


b.
A167915

Remove the 6 nuts, exhaust manifold sub-assembly RH and gasket.


Hide 89467B 10.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

Hide 89465 11.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)