Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › THROTTLE BODY
RM25T0E _51 Engine / Hybrid System _029758 1GR-FE ENGINE CONTROL _0135331 THROTTLE BODY A

1GR-FE ENGINE CONTROL  THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 22030 1.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Install a new gasket to the intake air surge tank.


b.

Install the throttle body with motor assembly with the 4 bolts.

Torque:
11 N*m (112 kgf*cm, 8 ft.*lbf)


c.

Connect the throttle body with motor connector.


d.

Connect the No. 4 water by-pass hose and No. 5 water by-pass hose, and slide the 2 hose clamps to secure the hose.


Hide 17705 2.INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE

Hide 5.PERFORM INITIALIZATION

NOTICE:
·

Be sure to perform this procedure after reassembling the throttle body or removing and reinstalling any throttle body component.

·

Perform the following procedure after replacing the ECM, throttle body or any throttle body components. The following procedure should also be performed if the throttle body is cleaned.

·

Be sure to perform this procedure after replacing the ECM and reconnecting the battery cable.



a.

Disconnect the EFI and ETCS fuses at the same time. Wait at least 60 seconds, and then reconnect the fuses.


b.

Turn the ignition switch to ON without operating the accelerator pedal.

NOTICE:

If the accelerator pedal is operated, perform the above steps again.



c.

Connect the GTS to the DLC3 and clear the DTCs.

Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR


d.

Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.

Standard idle speed:

650 to 750 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that the shift lever is in neutral.




e.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.

Powertrain > Engine > Data List
Tester Display
Throttle Sensor Position
50003 61 72

f.

Perform a road test and confirm that there are no abnormalities.