Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › MASS AIR FLOW METER
RM25T0E _51 Engine / Hybrid System _029758 1GR-FE ENGINE CONTROL _0135334 MASS AIR FLOW METER G

1GR-FE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter inspection according to the procedures below.

·

Only replace the mass air flow meter when the mass air flow meter value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter platinum hot wire (heater).



PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.

Read the value of Data List item "MAF" using the GTS.

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).

·

During this inspection, do not use an exhaust air duct on the exhaust pipe.



i.

Turn the ignition switch to ON (do not start the engine).


ii.

Turn the GTS on.


iii.

Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.

Powertrain > Engine > Data List
Tester Display
MAF
50003 61 319

iv.

Wait for 30 seconds, and then read the Data List according to the display on the GTS.

Standard:
Item Condition Specified Condition
MAF
·

Engine not running

·

30 seconds after ignition switch is turned to ON


Less than 0.52 gm/sec.


If the result is not as specified, replace the mass air flow meter.

If the result is within the specified range, check the intake air temperature sensor (thermistor) resistance.

Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION