Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › KNOCK SENSOR
RM25T0E _51 Engine / Hybrid System _029758 1GR-FE ENGINE CONTROL _0135338 KNOCK SENSOR A

1GR-FE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL KNOCK SENSOR

a.
A328406C02
0.458,0.24 0.771,0.396 0.313,0.156 10 false *A 0.448,3.5 0.76,3.656 0.313,0.156 10 false *B 0.729,0.719 1.042,0.875 0.313,0.156 10 false *a 1.333,0.177 1.646,0.333 0.313,0.156 10 false *b 0.698,3.99 1.01,4.146 0.313,0.156 10 false *c 2.573,0.906 2.885,1.063 0.313,0.156 10 false *d 3.135,3.073 3.354,3.281 0.219,0.208 10 false *c 1.344,3.438 1.656,3.594 0.313,0.156 10 false *b 2.563,4.177 2.875,4.333 0.313,0.156 10 false *d
*A for Bank 2
*B for Bank 1
*a Engine Rear
*b Top
*c Engine Front
*d 0 to 15°


Install the 2 knock sensors with the 2 bolts as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Connect the 2 knock sensor connectors.


Hide 16332 2.INSTALL NO. 1 WATER OUTLET PIPE

a.

for Type A:

Install the No. 1 water outlet pipe with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

for Type B:

Install the No. 1 water outlet pipe with the 2 nuts and bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Attach the 4 wire harness clamps.


Hide 11101 3.INSTALL CYLINDER HEAD SUB-ASSEMBLY RH (for Bank 1)