CHECK DTC
Turn the ignition switch to ON.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
| *1 | Normal |
| *2 | DTC 13 |
| *3 | DTC 31 |
| *a | ON |
| *b | OFF |
| *c | 0.25 seconds |
| *d | 4.0 seconds |
| *e | 1.5 seconds |
| *f | 2.5 seconds |
| *g | 0.5 seconds |
Read the DTCs output by the glow indicator light. As an example, the blinking patterns for a normal system code and DTC 13 and 31 are as shown in the illustration.
If a DTC or normal system code is not output, check the TC and CG Terminal Circuit (See page Engine / Hybrid System>1HZ (ENGINE CONTROL)>ECD SYSTEM>TC and CG Terminal Circuit).
Check the details of the malfunction using the DTC chart (See page Engine / Hybrid System>1HZ (ENGINE CONTROL)>ECD SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
Disconnect the SST from terminals 13 (TC) and 4 (CG).
In the event that 2 or more trouble codes are output, indication will begin from the smallest numbered code and continue in order to the largest.