Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › ECM › 2014.08–2017.01
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0135352 ECM A

1VD-FTV ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89661 1.INSTALL ECM

a.

Clean the ECM seal's surface with non-residue solvent.


b.

Attach a new gasket to the ECM.


c.

Install the ECM with the 4 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


d.
A163714N01
0.927,2.156 1.198,2.354 0.271,0.198 10 false 90° 0.917,0.969 1.188,1.167 0.271,0.198 10 false 90°

Connect the 2 connectors and push each lock lever down to lock the connectors.

NOTICE:
·

Make sure that the lock levers are raised 90° before connecting the connectors. Failure to do this may cause the lock levers and terminals to break.

·

Do not twist the wire harness when connecting the connectors.




Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 5.INITIALIZE LEARNED VALUE OF SUPPLY PUMP ASSEMBLY