Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0135355 CRANKSHAFT POSITION SENSOR A

1VD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 53737B 1.REMOVE FRONT FENDER APRON SEAL LH

a.

Remove the 11 clips and front fender apron seal LH.


Hide 16361A 2.REMOVE FAN AND GENERATOR V BELT

Hide 17875 3.REMOVE INTAKE AIR CONNECTOR PIPE

a.

Disconnect the engine coolant temperature sensor connector.


b.
A308582

Detach the wire harness clamp to disconnect the wire harness from the intake air connector pipe.


c.

Slide the clip and disconnect the ventilation hose from the intake air connector pipe.


d.

Loosen the 2 hose clamps.


e.

Remove the 2 bolts and remove the intake air connector pipe.


Hide 16630H 4.REMOVE IDLER PULLEY ASSEMBLY (w/o Air Conditioning System)

A165480

a.

Remove the 3 bolts and idler pulley assembly.


Hide 5.DISCONNECT COOLER COMPRESSOR (w/ Air Conditioning System)

Hide 11301K 6.REMOVE CRANKSHAFT POSITION SENSOR

A163138

a.

Disconnect the connector from the crankshaft position sensor.


b.
A163139

Disconnect the crankshaft position sensor wire harness clamp.


c.

Remove the bolt and crankshaft position sensor from the timing chain cover sub-assembly.