Home › Engine / Hybrid System › 1VD-FTV (FUEL) › COMMON RAIL (w/o DPF) › 2014.08–2022.09
RM25T0E _51 Engine / Hybrid System _029770 1VD-FTV FUEL _0135397 COMMON RAIL(w/o DPF) A

1VD-FTV FUEL  COMMON RAIL(w/o DPF)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, watching time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17940D 4.REMOVE INTERCOOLER ASSEMBLY

Hide 23706 6.REMOVE NO. 6 INJECTION PIPE SUB-ASSEMBLY

Hide 23820A 7.REMOVE COMMON RAIL RH

a.
A271422

Using a 17 mm union nut wrench, loosen the union nut and disconnect the No. 5 injection pipe sub-assembly.


b.

Disconnect the fuel pressure sensor connector.


c.

Remove the 2 bolts and common rail RH.

NOTICE:

Do not remove the fuel pressure sensor from the common rail RH. If removed, replace the common rail RH.



Hide 23239D 8.REMOVE NO. 1 FUEL HOSE

A163355

a.

Slide the 2 clamps and remove the No. 1 fuel hose from the No. 5 nozzle leakage pipe and No. 5 fuel pipe sub-assembly.


Hide 23765 9.REMOVE NO. 5 NOZZLE LEAKAGE PIPE

A163354

a.

Remove the union bolt, gasket and No. 5 nozzle leakage pipe from the common rail LH.


Hide 23810A 10.REMOVE COMMON RAIL LH

A163353

a.

Remove the 2 bolts and common rail LH.

NOTICE:

Do not remove the fuel pressure limiter from the common rail LH. If removed, replace the common rail LH.